Bedienungsanleitung Smeg se2642id (Seite 5 von 11) (Englisch)

331786

Zoom out

Zoom in

Vorherige Seite

1/11

Nächste Seite

224244 25

Safety switch-off

The maximum operating time for each individual cooking zone

is limited, and details are shown in the enclosed table of times.

When the safety switch-off has switched off the touch control

system, a “0” or an “H” is shown in the cooking level display

if there is still any residual heat left. Pressing the on/off key

makes the control system ready for operation again.

If more than one key is pressed simultaneously - with the ex-

ception of the Minus and Plus keys - the control system will not

accept this as a valid command. If one or more keys are activat-

ed for longer than 30 seconds, for example by boiling over or

the weight of a pan, the control system assumes that there is an

error and switches off automatically. If key operation continues,

a constant acoustic signal sounds.

2. Things to watch out for

2.1 Important tips for induction

2.1.1 Induction cooking zones and cooking ware

Your hob is equipped with induction cooking zones which are characterised by high performance when it comes

to quick heating and energy saving. The heat is generated direct in the bottom of the pots, where it's needed, with-

out a loss of energy through the ceramic hob. That's why the energy consumption is lower than with normal radi-

ation heating elements, as for example with glass ceramic hobs.

The glass is not directly heated, though it becomes hot due to the effect of heat reflected by the pan. When the

cooking zones are switched off, a hot cooking zone is indicated by the flashing “H” (residual heat indicator). In

induction cooking zones, heating is achieved by means of an induction coil installed below the ceramic hob which

produces an electromagnetic field. With the use of magnetizable pans or dishes made of steel, steel mesh or iron

cast (suitable for induction ceramic hob), energy is transmitted directly to the bottom of the equipment.

Only use induction cooking zones with suitable cooking utensils, made of materials such as steel, steel

mesh or cast iron. Stainless steel pans with copper or aluminium bottoms are not suitable and neither is

cookware made of fireproof glass or terracotta or ceramic cookware (for the minimal or maximum diame-

ter of pot bottoms see the chart in section 2.1.3). When you purchase a set of pans, check for the label

“Suitable for induction”.

2.1.2 Protection against overheating

The ceramic hob is provided with a protection against overheating, which protects the electronics against damage.

The protection against overheating works in several stages. If there is a significant increase in the heat of the

ceramic hob, then a two-stage fan switches on. If this is not enough, then the power level mode will be deactivated

and the power for the individual cooking zones decreased or switched off completely. Full power will be available

again once the ceramic hob has cooled down.

Table of times

MOT = maximum operating time,

in hours

Cooking level MOT (h)

61,5

71,5

81,5

91,5

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Smeg se2642id Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Smeg se2642id

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info