Bedienungsanleitung Smeg STX2_3 (Seite 13 von 27) (Englisch)

22169

Zoom out

Zoom in

Vorherige Seite

1/27

Nächste Seite

User instructions

4. Operating instructions

Once the dishwasher has been correctly installed, prepare for use as follows:

•

Adjust the water softening system;

•

Add the regenerating salt;

•

Add the rinse aid and detergent.

4.1 Using the water softening system

The amount of scale contained in the water (water hardness

index) can cause whitish staining on the dry dishes, which

tend to become dull over time. The dishwasher is equipped

with an automatic softening system which uses a special

regenerating salt to reduce the hardness of the water.

The dishwasher is factory set for water hardness level

(average hardness

41-60°dF

–

24-31°dH

When using water of medium hardness, the regenerating salt container should be refilled after

approximately

20 washing cycles

. The salt container can hold approximately

1.7 Kg

of salt in

grains. Some models are equipped with an optical no-salt indicator. In these models, the cap of the

salt container contains a green float which descends as the salt concentration in the water drops.

When the green float can no longer be seen through the transparent cap, the container must be

topped up with regenerating salt. The container is situated at the bottom of the dishwasher. After

removing the lower basket, unscrew the salt container cap by turning it anticlockwise and pour in

the salt using the funnel supplied with the dishwasher. Before replacing the cap, remove any salt

residues from around the opening.

•

When using the dishwasher for the first time, in addition to the salt it is also necessary to add

one litre of water

to the container.

•

Each time the salt container is refilled, make sure that

the cap is securely closed

. The

mixture of water and detergent must never penetrate the salt container, as this would

compromise the operation of the regeneration system. In the event of this occurring, the

warranty will be invalidated.

•

Only

use regenerating salt specially formulated for domestic dishwashers. If using salt tablets,

do not fill the container completely

•

Do not use table salt

as it contains insoluble substances which, over time, may damage the

water softening system.

•

When necessary, refill the regenerating salt container

before starting the washing program

In this way, the excess saline solution will be immediately removed by the water; the prolonged

presence of salt water inside the tank may lead to

corro sion

Be careful not to confuse the salt and detergent packages

; adding detergent to the salt

container will

damage

the water softening system.

ADJUSTING THE WATER SOFTENING SYSTEM

The dishwasher is equipped with an electronic device for adjusting the water softening setting

according to the hardness of the water.

Depending on model, the setting may be made

electronically

or by means of a

selector switch

SALT

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Smeg STX2_3 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Smeg STX2_3

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info