Bedienungsanleitung Smoov One O10 (Seite 27 von 37) (Englisch)

785804

Zoom out

Zoom in

Vorherige Seite

1/37

Nächste Seite

11.3 General information about charging the batteries

•Do not charge the batteries in the presence or vicinity of flammable liquids or gases.

•In the (unlikely) event of a battery overheating or catching on fire, you must ensure that the battery does not come into contact with

water or other liquids. The only suitable extinguishing agents recommended by the battery manufacturers are sand or a Class D fire

extinguisher.

•Never complete the charging process in rooms where moisture may affect the SMOOV O10 components and the batteries contained

therein.

•Never charge the battery at temperatures below 0 °C or above 40 °C. If you attempt a charging process outside of this temperature

range, the charging process will be automatically aborted.

•It takes no more than 6 hours to charge the batteries of the drive unit.

11.4 Safety instructions for the charger and the charging process

The drive unit is to be switched off completely prior to commencing the charging process.

If the drive unit is attached to the wheelchair during charging, the wheelchair is to be secured by means of its parking

brakes to prevent it from rolling away inadvertently!

•Always recharge the batteries of both components in good time.

•Always use the charger supplied by Alber to charge the batteries. The charging process will end automatically as soon as the battery is

fully charged. As such, overcharging is impossible.

•Never user any charger other than the one supplied by Alber to charge the drive unit.

•Always charge the control unit battery together with the drive unit battery (see chapter 4.2.2).

•If you use a separate charger not supplied by Alber to charge the control unit battery, such a charger must comply with the technical

parameters listed in chapter 4.2. Chargers that do not meet the specified parameters must not be used under any circumstances.

•Do not use the Alber charger to charge any batteries other than the batteries installed in the drive unit and control unit.

•Connect the drive unit and control unit to the charger only for as long as is necessary to charge the batteries.

•To charge the batteries, first plug the mains plug [19] into a mains socket and then plug the charging plug [18] into the charger socket [1].

After completion of the charging process, you must first disconnect the charging plug [18] from the charger socket [1], then disconnect

the mains cable [19] of the charger from the socket. Please observe the information in chapter 4.1.

•Do not expose the charger to moisture of any kind (water, rain water, snow, etc.) during charging.

•Be aware of condensation. If the charger is brought from a cold area into a warm room, condensation may occur on and in the device.

In this case, refrain from using the charger until all the condensation has evaporated. Please note that this may take several hours.

•Never carry out the charging process in rooms where moisture may affect the charger.

•Never carry the charger by its power cable or the charging cable.

•Never tug at the power cable to disconnect the charger from the socket.

•Lay the power cable and the attached charger cable in such a way that nobody can step on it or trip over it and in such a way that

cable and charger are protected against any other harmful effects or stress.

•Do not ever operate the charger if the power cable, the charger cable or the plugs attached to the cables are damaged. Damaged parts

must be replaced immediately by a specialist dealer that has been authorised by Alber.

•Do not use or disassemble the charger if it has received a hard blow or was dropped or damaged in some other way. Take the damaged

charger to a specialist dealer that has been authorised by Alber to perform repairs.

•The charger must not be used by young children.

•The charger may only be operated with a mains alternating voltage of 100 V to 240 V.

•Never attempt to dismantle or modify the charger.

•Do not cover the charger during the charging process or place any objects on top of the device.

•Never subject the cable or plug to any pressure. Overstretching or bending the cable, allowing cables to get trapped between a wall and

a window frame, or placing heavy objects on a cable or a plug may result in electric shock or fire.

•Never connect the terminals of the charger cable to any metal objects.

•Ensure that the mains plug is firmly inserted in the socket.

•Do not touch the mains plug or the charger cable plug with wet hands.

•Do not use the charging plug and/or the mains plug if they are wet or dirty. Before plugging them in, clean the plugs using a dry cloth.

•Ensure that no moisture can get into charger sockets [1] and [14] after the charger is disconnected.

•The mains plug is used to interrupt the power supply to the charger. As such, objects must never cover the charger or obstruct its use.

•Technical modifications of any kind are not permitted on the drive unit and control unit, nor are they permitted on the charger.

•If necessary, check the electrical connections to ensure that the charger is set up correctly and not covered by any other objects.

• The charger is only permitted for charging the SMOOV O10. Use with other products is not permitted and can result in significant dam-

age to this charger and to the other

• The charger is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience

Smoov One O10 Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Smoov One O10

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info