Bedienungsanleitung Snom A230 USB DECT Dongle (Seite 1 von 3) (Englisch)

809903

Zoom out

Zoom in

Vorherige Seite

1/3

Nächste Seite

v2021001_w

A230

USB DECT Dongle

Important Information

Please read the instructions on safety and disposal and on how to set up and use the device before using it

and also give them to other users to read or inform those users of their contents. Save this document and

do not give the device to third parties without it.

Safety Instructions

Follow the instructions in the manual and other applicable documentation of the device.

• Handle the product with care. Crushing, wrenching, or dropping it from even moderate heights may

damage it.

• This device is for indoor use only! Do not install outdoors - NOT FOR OUTDOOR USE!

• Do not install the device in rooms with high humidity (for example, in bathrooms, laundry rooms, damp

basements).

• Do not immerse the device in water and do not spill or pour liquids of any kind onto or into the device.

• Do not expose the product to extreme heat.

Standards Conformance

This device complies with Directive 2014/53/EU and the essential health, safety, and environmental

requirements of all relevant European and Australian directives. This device complies with the Radio

Equipment Regulations 2017 and the essential health, safety, and environmental requirements of all

relevant UK legislation. The declaration of conformity can be downloaded at https://www.snom.com/

conformity. Unauthorized opening, changing, or modifying the device will cause the warranty to lapse

and may also result in the loss of CE conformity. In case of malfunction contact authorized service

personnel, your seller, or Snom.

Safety: IEC 62368-1

Disposal

This device is subject to European Directive 2012/19/EU and may not be disposed of with general

household garbage. If you do not know where you may dispose of the device at the end of its lifespan,

contact your municipality, your local waste management provider, or your seller.

Registering a wireless device (speakerphone, headset)

1. Remove the dongle‘s protective cap.

2. Insert the dongle into the USB port.

3. Press the key on the dongle for 4 seconds to enter registration mode; the red

LED begins to double-ash rapidly. You now have 10 seconds to register the

device.

4. For pairing with A170/A150 headsets and C52-SP, see reverse side. For pairing

with other wireless devices, please refer to the manuals of the devices.

Deregistering

1. Press the key on the dongle for 10 seconds to enter deregistration mode. After 4 seconds the red LED

starts to double-ash; after 10 seconds the LED starts to ash red rapidly, indicating that the dongle has

entered deregistration mode.

2. Release the key and press it again for 1 second to conrm deregistration. The LED turns green for three

seconds, turns o for one second and then shows steady red light.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Snom A230 USB DECT Dongle Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Snom A230 USB DECT Dongle

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info