675928
15
Zoom out
Zoom in
Vorherige Seite
1/138
Nächste Seite
13
Clean Connect 500 display. Press again to
turn off
Bluetooth®
.
If the Airfresh Clean Connect 500 is connected to a mo-
bile device, it can be controlled via the control console
of the housing as well as via the Soehnle Connect app.
UV-C lamp and night-time mode
Press the button (H) once to switch on
the UV-C lamp inside the Airfresh Clean
Connect 500 (UV-C indicator is on). Press
again to activate the night-time mode
without turning off the UV-C lamp (UV-C
indicator light is on, NIGHT indicator light
flashing). Press the (H) button again to
turn off the UV-C lamp (UV-C indicator
light is off, NIGHT indicator light flashes),
or turn off both (UV-C indicator light is off,
NIGHT indicator light is off).
Night mode
In the night-time mode, you can run the
Airfresh Clean Connect 500 without be-
ing disturbed by additional light sources.
Once you activate the night-time mode,
all indicator lights on the device will soon
be turned off without the device switch-
ing off. All previous settings for operating
time and fan speed will remain un-
changed. Activation of the night-time
mode is indicated by flashing of the indi-
cator light before the illumination switch-
es off completely.
The unit can run either in night-time mode or in au-
tomatic mode. These two modes cannot be activated
at the same time.
9. Cleaning and care
Cleaning the combination filter
Regular cleaning of the combination filter (1x
month) ensures faultless operation of the Air-
fresh Clean Connect 500 and the greatest possi-
ble room air quality.
Proceed as follows:
1. Switch the device off prior to cleaning and
disconnect the power plug.
2. Turn the device upside down and place it on
a solid surface (2.1).
3. Open the screw cap on the bottom of the
device (2.2).
4. Remove the housing base by lifting it up
(2.3).
5. Remove the combination filter (2.4) and
clean it. Replace the filter and ensure that it is
inserted correctly.
The pre-filter is attached to the lter with a hook and loop
fastener. Clean the pre-lter under running water. Ensure
that the pre-lter is dry before reattaching into the EPA
lter. EPA and activated carbon filter should be cleaned
only with a vacuum cleaner.
6. Close the device and fasten the screw cap.
Turn the device right side up and place it on
a solid surface.
7. Reconnect the power cord to a power outlet
and switch the device on.
Cleaning the housing
Switch the device off prior to cleaning and dis-
connect the power plug. Clean the housing of
Airfresh Clean Connect 500 with a slightly damp
cloth.
EN
15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

soehnle-68098---airfresh-clean-connect-500

Suche zurücksetzen

  • kann ich dieses gerät per schalter direkt am gerät selbst starten? Eingereicht am 9-1-2022 09:33

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Soehnle 68098 - Airfresh Clean Connect 500 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info