Bedienungsanleitung Sogo SS-13005 (Seite 20 von 36) (Deutsch, Englisch, Französisch, Italienisch, Portugiesisch, Spanisch)

798555

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

español english français

cabbage emit gases when vacuum packed fresh

for refrigeration. To prepare these foods for vacuum

packing, blanch and freeze.

GENERAL RULES FOR FOOD SAFETY

Food safety rules are based on scientic study as

well as common sense. The following rules and

important food safety and optimal food storage.

1. Once you have heated, defrosted or un-refrigerated

perishable foods, consume them immediately.

2. After opening canned food or commercially vacuum

packed foods, they can be re-vacuumed packed.

Follow the instructions to refrigerate after opening

and store re-vacuumed packages properly.

3. Don’t defrost foods in hot water or via other heat

sources. It doesn’t matter whether they are vacuum

packed or not.

4. Don’t consume foods if they are perishable and

have been left out at room temperature for more

than a few hours. This is especially important if

they have been prepared with a thick sauce, in a

vacuum package, or in a low oxygen environment.

5. Spread vacuum packages evenly throughout

the refrigerator or freezer to cool down food

temperature quickly.

CLEANING AND MAINTENANCEY

Vacuum sealer

1. Always unplug the unit before cleaning.

2. Do not immerse in water or any other liquid.

3. Avoid using abrasive products or material to clean

the unit, for they will scratch the surface.

4. Use a mild dishwashing soap and a warm,

damp cloth to wipe away food residue or around

components.

5. Dry thoroughly before using again.

Note: The foam gaskets around the vacuum

chamber should be dried thoroughly before re-

assembling, when re-assembling, is careful to

prevent any damage, and assemble as original

position to ensure no vacuum leaking.

Vacuum bags

1. Wash bags in warm water with a mild dishwashing

soap

2. When wash bags in dishwasher, turn bags inside

out and spread them over top rack of dishwasher,

so entire surface is exposed to the washing water.

3. Dry thoroughly before reusing.

IMPORTANT: To avoid possible illness, do not

reuse bags after storing raw meats, raw sh or

greasy foods. Do not reuse bags that have been

microwaved or boiled.

Accessories

Washing all vacuum accessories in warm water

with a mild dishwashing soap, But do not immerse

cover in water.

1. Canister bases (not lids) are top rack dishwasher

safe. But canister cover should be wiping down

with a damp cloth.

2. Ensure the accessories to be dry thoroughly before

reusing.

3. Canister and cover is not allowed to use in

microwave or freezer.

Storing Your Vacuum Sealer:

1. -Keep the unit in a at and safe place, out of the

reach of children.

2. Do remember to make sure the lid of appliance is

unlocked when not in use and in storage. Keep the

cover locked will distort the foam gaskets causing

leaking.

MAINTENANCE KIT INSTRUCTIONS

Replacing the gasket:

1. Turn “ O” the switch and remove the Power Cord

from the electrical outlet.

2. Make sure the unit is completely cool.

3. Open the Acrylic Vacuum Lid.

4. Remove the gasket from the groove on the

underside of the Acrylic Vacuum Lid.

5. Remove the gasket from the groove in the Plastic

Vacuum Chamber.

6. Set a new gasket on the groove in the Plastic

Vacuum Chamber. Work the seal into the groove

with your ngers until done.

7. Position a new gasket into the groove in the Acrylic

Vacuum Lid. Work the seal into the groove with

your ngers until done.

Replacing the Teon tape:

1. Turn “O” the switch and remove the Power Cord

from the electrical outlet.

2. Make sure the unit is completely cool.

3. Open the Acrylic Vacuum Lid.

4. Pick at either end of the Teon Tape covering

the Seal Bar Heating Element with a ngernail

or sharp-edged tool until it lifts slightly. Grasp the

loose end and slowly pull the Teon Tape back over

itself until fully removed.

6. Remove the backing from a new wide strip of

Teon Tape for the Seal Bar Heating Element.

Be careful not to allow the Teon Tape to contact

anything including itself while the adhesive side is

exposed.

7. Hold one end of the Teon Tape in each hand.

Stick the left end of the Teon Tape to the at area

on the Plastic Vacuum Chamber just left of the

Seal Bar Heating Element. Apply the Teon Tape

from left to right over the Seal Bar Heating Element

until done. Make sure there are no wrinkles or folds

in the Teon Tape once applied. The Teon Tape

should fully cover the Seal Bar Heating Element.

TROUBLE SHOOTING

Nothing happens when I try to vacuum package

1. Check power cord to see if it is rmly plugged

into electrical outlet.

2. Check switch to see if it’s setting is “o”.

3. Examine power cord for any damages.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sogo SS-13005 Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info