Bedienungsanleitung Sogo SS-5675-R (Seite 24 von 76) (Deutsch, Englisch, Französisch, Italienisch, Portugiesisch, Spanisch)

797957

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

español english français portuguese deutsch italiano

ENERGY SAVING MODE

The machine enters energy saving model automatically once the machine is idle for 15 minutes, the

back light of two buttons and power indicator will switch o󰀨. To quite energy saving mode, please

press power button, appliance will start to warming up with lights blinking, when the buttons are lit

steadily, the machine is ready to brew co󰀨ee.

DECALCIFICATION

Decalcication/Maintenance

Drinking water varies according to region. The lime particles in hard drinking water are deposited as

residues in the machine and can block the piping and cause damage to it. To prevent this, make sure

to decalcify the machine at the very least after making 300 to 400 cups of co󰀨ee or in any case if the

output falls signicantly, after one or two months. Decalcication must be done correctly to prevent

damage. So, it is essential to follow these instructions.

Important:

– Never clean the machine with vinegar. This causes damage and makes your co󰀨ee taste bad.

– Damage caused by incorrect decalcication or failure to decalcify is not covered by the guarantee.

– Caution: beware of hot water!

1. Recommendations: purchase commercially available decalcier (decalcifying liquid), diluted

according to the manufacturer‘s instructions; pour the mixture in the water tank

2. Make sure there is without capsule inside the machine.

3. Place a large bowl under the dispensing head to collect the decalcication diluted and lime

residue.

4. Fill the water tank with water to maximum level mixed with decalcifying solution, make sure the

solution is dissolved completely.

5. Press the large button to run decalcifying water as you brew co󰀨ee normally, repeat for several

times to run out the entire tank water.

6. Repeat the process to run another tank of water mixed with decalcifying solution.

7. Repeat the process to Flush out the intern circuit with a tank of fresh water (without the

decalcifying solution) to clean the internal circuit completely.

INDUCING THE WATER, MANUALLY INTO COFFEE MACHINE AND PUMP

The very rst time or after long pauses (e.g. holidays) the machine might not pump the water. So

Before using the machine again this short procedure of inducing the water manually into the machine

using the pipe, helps pump and internal circuit to self-priming.

Insert the pipe into the water entrance located underneath water tank.

Fill water into the pipe.

Push manually with the help of pusher to introduce the water into the machine, so that the internal

circuit get lled with water.

After doing steps mentioned above machine will be able to pump the water on its own.

Note: If necessary, repeat the process for 2-3 times.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sogo SS-5675-R Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info