719065
9
Zoom out
Zoom in
Vorherige Seite
1/62
Nächste Seite
• Do not touch the appliance with wet hands when in
operation.
• Do not use the appliance on wet surfaces or
outdoors.
• The appliance must be connected to a power socket
with a suitable ground connection.
• Do not use on sensitive areas such as eyebrows,
moles, warts, open wounds, cuts, burns, etc.
• People insensitive to heat must be careful when they
use the device.
• Never use the appliance without wax. The device
is designed to melt and heat depilatory wax,
whether empty pot heats the device may be
damaged.
•Do not use with the lid on. The lid is designed to
prevent the accumulation of dust when the
machine is not being used. Melt wax with the lid
on, may cause damage to the device.
2 MAIN COMPONENTS
1 Lid
2 Filter (removable).
3 tub 1
4 tub 2
5 light .
6 temperature regulation controls.
7 Spatula
3 OPERATION
Use this appliance to remove hair from the
desired areas of the body. It is not advisable to remove
hair from the armpits and eyebrows at home. This
treatment should be left to a beautician.
Hot wax hair removal has the advantage of
reducing the rate of hair growth.
To obtain an excellent result, hair should be at
least 2 to 3 millimetres in length and skin should be
clean without cream or talc.
1 Plug in the appliance.
2 Remove lid and pour the capsules of wax into tub 1
(approx. 200 gr.).
3 Set the tub's temperature regulator to wax melting
mode (Fig. 1).
The light will then come on.
The temperature regulator of vat 2 will be in the
"stop" setting (Fig. 2).
4 Stir the wax now and again with the spatula.
5 When it has taken on the consistency of a thick
syrup. re-adjust the temperature regulator to hair
removal setting (Fig. 3). The light will go out.
After a few minutes the light will come on again
and the wax should be at a suitable temperature for
hair removal.
6 Mix the wax to ensure an even temperature
throughout.
7 Using the spatula place a little wax on the back of
your hand to test the temperature. If this is suitable for
you. you may begin hair removal.
Thanks to the thermostat, the temperature of the
wax will remain constant.
8 Run your hand along your legs using an upward
motion to flatten out the hairs.
9 Using the large spatula, spread out the wax in strips
of approximately 6 cm in length and 3 cm in width.
Wax should always be applied in the opposite
direction to the growth of the hair.
10 Removing the wax
• Wait for 30 to 60 seconds until the wax strip
becomes dry to the touch.
• Hold your skin taut. Grasp the thicker end of the
wax, and pull the strip back as quickly as you can,
against the direction the hair grows (from ankle to
knee). Pull the strip back on itself, close to the skin
rather than away from it. (Fig. 4)
• To soothe the skin immediately after you remove the
strip, press the area with your hand.
• Use some used wax or oil to remove wax traces. This
wax doesn’t come out with water, soap or alcohol.
(Fig. 4)
11 Place the strips of used wax in the filter in tub 2
and set tub 2’s temperature regulator to wax melting
mode (Fig. 1).
12 When the wax has melted, filter it, clean, then
remove the filter and place it under cold water.
13 If necessary, put back the temperature regulator to
the hair removal setting (Fig. 3).
You may continue hair removal by using the
wax in tub 2, then placing the used strips in the filter
which you have now placed into tub 1.
9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Solac DC7502 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info