Bedienungsanleitung Solis 868 - Cremissimo (Seite 29 von 34) (Deutsch, Englisch, Französisch)

663504

Zoom out

Zoom in

Vorherige Seite

1/34

Nächste Seite

5756

Caution:

– The jug is very hot during and after use! Therefore, never place the hot jug on a

heat sensitive surface!

– Never place the hot jug on the power cord.

 ADDING INGREDIENTS

• If you want to add ingredients to the milk, the frothing process always has to be

running for a few seconds already. You can measure the solid or liquid ingredi-

ents off with the measuring cap and gradually pour them into the milk through

the lid opening. If you have set the temperature to a range between WARM and

HOT, you should wait for a while before adding the ingredients so that the milk

can warm up and the ingredients can dissolve more quickly.

• Always add the ingredients to the jug slowly and in small amounts. If you add

the ingredients too quickly, the frothing disc could detach from the seating pin

or prematurely stop the frothing process.

• The result of frothing depends on the added ingredients. If you add e.g. solid

ingredients like syrup, thick powder or large ﬂakes, the froth will not be as creamy

and ﬂuffy.

Notes:

– The milk frother is not suitable for mixing dry ingredients like ground nuts, whole

spices or fresh herbs or for melting large pieces like chocolate cubes. The jug must

always be ﬁlled up to the MIN marking at least with liquid (milk).

– The milk frother is designed for frothing and stirring milk, it can not whip cream,

prepare dessert sauces or stir soups, eggnog or sauces.

5. Place the jug back on the motor base, the outer bottom of the jug as well as the

opening in the bottom must be dry and clean.

6. Turn the START/STOP rotary knob to the desired temperature. If you want to froth

resp. stir milk for a cappuccino or a caffè latte, we recommend a temperature

setting in the OPTIMUM MILK TEMP range. Of course, different temperature

settings ﬁtting personal tastes are also possible.

Should you change the temperature setting during use, the appliance heats the

jug contents to the newly set temperature.

Push the START/STOP button inwards, the button surround ﬂashes and the

frothing process starts.

Note:

Never remove the jug from the motor base while the appliance is in use. If you want

to stop the operation ahead of time, you can simply press the START/STOP button

again.

8. Once the milk has reached the set temperature, the appliance stops automati-

cally and a twofold signal is sounded. Heating up usually takes between 2 and

7 minutes, depending on the amount of milk and the temperature setting. Wait

for the built-in ventilator to stop and pull the power plug. Carefully take the jug

out of the motor base by the handle and keep in mind that the jug as well as the

milk can be very hot. Do not place the hot jug on a heat sensitive surface, e.g.

on plastic or on a tablecloth, as it might melt or be scorched.

9. Remove the lid and carefully pour the frothed milk into the cup.

10. Clean the jug with the lid and the measuring cap as well as the frothing discs

after every use. The jug with the frothing disc should be cooled down completely

before you disassemble it.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Solis 868 - Cremissimo Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info