Bedienungsanleitung Solis Grind and Iinfuse Compact 1018 (Seite 84 von 108) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

730380

Zoom out

Zoom in

Vorherige Seite

1/108

Nächste Seite

167166

GB GB

s

TROUBLESHOOTING

CAUTION: Should there be any problems or impairments to the functionality of the

appliance, immediately switch the appliance off and disconnect the power plug.

Problem Possible cause Solution

The machine does

not dispense any

hot water.

Air has intruded into the

water circuit and causes

the pump to run idly.

The steaming nozzle

opening is clogged.

Make sure that the water tank is correct-

ly installed and that the water level does

not stand underneath the MIN marking.

Repeat the steps described in “Before

ﬁrst use” / “C. Rinsing the machine”

resp. “Water tank runs empty during

use” (p. 155).

Remove potential residues on the open-

ing with the large needle of the cleaning

tool.

The machine does

not dispense

steam.

There is only little water

in the tank so that the

pump can not suck in

any water.

The steaming nozzle

opening is clogged.

Check the water level in the water tank.

If necessary, ﬁll the tank up to the MAX

marking.

Remove potential residues on the open-

ing with the large needle of the cleaning

tool.

Steam escapes

from the edges of

the portaﬁlter.

Espresso is being dis-

pensed while the steam

function is activated.

Stop the espresso extraction by pressing

the activated espresso button again.

Turn the steam / hot water control to

the position in the centre  to deacti-

vate the steam function. Wait for all four

function lights to light up constantly and

start another espresso extraction.

Coffee runs out

from the edges of

the portaﬁlter.

Too much ground coffee

in the ﬁlter insert, pre-

venting the portaﬁlter

from being fully turned

into the brewing head.

Carefully and slowly turn the porta-

ﬁlter out of the brewing head. Please

note that the pressure could cause hot

splashes. Clean the brewing head with a

soft, moist sponge or towel. Reduce the

amount of ground coffee and restart the

espresso extraction. Please refer to the

tips given on p. 158/159.

Problem Possible cause Solution

Coffee runs out

from the edges of

the portaﬁlter.

Ground coffee is stuck to

the brewing head.

The holes in the ﬁlter

insert are clogged.

Clean the brewing head with a soft,

moist sponge or towel.

Carefully and slowly turn the portaﬁlter

out of the brewing head. Please note

that the pressure could cause hot splash-

es. Clean the holes in the ﬁlter insert

with a brush or the cleaning tool. Clean

the ﬁlter inserts as described in the sec-

tion “Cleaning” (p. 161).

The espresso is

watery and cold. The grind size is too

coarse.

If this is the ﬁrst espresso

you are making, the ﬁlter

insert might still be cold.

Choose a lower grind size to get more

ﬁnely ground coffee. This will yield a

stronger and hotter espresso.

Rinse the portaﬁlter with the ﬁlter insert

with hot water as described.

The grinder is

blocked or loud. There are impurities

among the coffee beans. Press the grind button to interrupt

the grinding process.

Proceed as described in the section

“If the grinder is blocked” (p. 160).

The appliance

is switched on

and the function

light of the

On/Off button

ﬂashes rapidly.

The steam / hot water

control is not set to posi-

tion in the centre .

Turn the steam / hot water control to the

position in the centre . The appliance

goes back to normal operation mode.

Too large amount

of espresso was

dispensed.

The extraction amount

for 1 or 2 cups was not

correctly set.

Reduce the extraction amount by mak-

ing a new setting. Please proceed as

described in the section “Programming

the amount of espresso” (p. 153).

Too large amount

of ground coffee

in the ﬁlter insert.

The amount of ground

coffee for 1 or 2 cups

was not correctly set.

Reduce the amount of ground coffee by

making a new setting. Please proceed as

described in the section “Programming

the amount of ground coffee” (p. 151).

The machine

makes loud noises

while the steam

function is active.

The loud noises originate

from the water pump

which works at high

pressure when steam is

dispensed.

Completely normal operation.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Solis Grind and Iinfuse Compact 1018 Seite 84

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info