Bedienungsanleitung Solo 421 (Seite 7 von 16) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

655923

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

- ENGLISH –

 With the spreader fitted, crank the handle and

determine if the spreader is set at a comfortable

height. Remove the spreader, adjust the strap

and try again until you are comfortable with fit

and function.

Lubrication Point

 With the spreader on it’s right side (crankhandle

side up), observe the small oil hole in the

gearcase.

 Add a few drops of light oil every four hours of

operation Figure C.

Adjusting the Spreader

Your spreader is adjustable for both volume and

direction. Five factors determine the volume and

derection. They are:

 Flow Limiter Stop - This brass stop nut allows

you to limit the hopper opening for consistent

delivery of material to the impeller.

 Flow Rate Lever - Look down into the hopper to

observe how the drop chute opening varies as

you adjust the flow rate lever.

 Directional Lever - This control adjusts the

point where the material is to be deposited on

the impeller and consequently, the width of

spread. The lever can be set for center, left or

right spreading. Figure D.

 Deflector Shield - Increase or decreases the

width of spread. Figure E.

 Cranking Speed - Cranking faster or slower

affects volume and coverage.

SPREAD RATE TABLE

Cran-

king

RPM

Pelletized

Fertilizer

Flow rate adjuster

setting # 3 (middle)

Pounds/Kg

Delivered/

per minute

Flow rate adjuster

setting # 6 (full open)

Pounds/Kg

Delivered/

per minute

55-60

Ø 2-3,5 mm

Ø 2-5 mm

Gras seed

4.4 / 2.0

3.75 / 1.70

0.70 / 0.32

7.44 / 3.37

10.0 / 4.54

2.0 / 0.91

Pelletized fertilizer is usually thrown about 10-12

feet (300-400cm) in front of the operator and about

5-7 feet on each side at 55-60 rpm. Grass seed

usually carries 5-6 feet (180-200 cm) forward and

4-5 feet (150-170 cm) to the side. A walking speed

of 2.5 to 3.0 feet per second (80-90 cm/sec) is

suggested.

Please test the product you are spreading to

achieve the manufacturer’s recommended

coverage.

FILLING THE HOPPER

 Move flow rate lever to zero position.

 Set spreader on a flat surface.

 Remove hopper lid.

 Fill hopper. For the initial use it is wise to partly

fill the hopper and practice spreading and making

adjustments.

 Replace hopper lid - the lid prevents spillage and

heilps keep dust and otrher material away from

the operator. When spreading chemicals be sure

to wear protective clothing, respirator and eye

protection.

 Do not load hopper while carrying spreader.

OPERATING INSTRUCTIONS

 Set spreader on a surface to safely and

conveniently fit the carry strap as outlined in

assembly section.

 Set deflector to desired position.

 Adjust spreading direction lever to the desired

position. Directional changes can also be made

simply by walking in the desired direction.

 While turning the crankhandle with your right

hand, move the flow rate lever with the left hand

to adjust flow rate. Flow limiter stop will control

flow rate. Caution: Keep hands away from

rotating impeller.

 After use, turn the flow rate lever to the closed

(zero) position. Crank the handle several times to

make sure no material residue is attached to

impeller. Clean the whole unit thoroughly using

soap and water.

OTHER OPERATINS SUGGESTIONS

 Walking speed: 2.5 - 3.0 feet per second (80-90

cm/sec.) .

 Crankhandle speed: 55-65 rpm.

 Each complete revolution of the crankhandle

causes the impeller to rotate 7 1/2 turns.

 Experiment to find the best setting.

 In windy conditions, plan your work so the wind is

behind you if possible.

STORAGE

 Empty hopper of contents. Store or dispose of

contents properly and in accordance with the

chemical manufacturer’s instructions.

 Check all bolts, nuts and screws for proper

tightness.

 Clean unit with soap and water.

 Dry.

 Store in safe place.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Solo 421 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info