Bedienungsanleitung Solo Port 423 (Seite 23 von 62) (Deutsch, Englisch, Französisch, Spanisch)

655794

Zoom out

Zoom in

Vorherige Seite

1/62

Nächste Seite

Maintenance and care

ENGLISH 7

5. Maintenance and care

Any cleaning, maintenance or repair jobs should

only be performed when the engine is stopped and

with removed spark plug cap.

The exception, of course, is carburetor tuning.

Any service jobs, other than those described in

this manual, should only be carried out by an

authorized service center. Only original parts may

be used for any maintenance and service work.

Never modify your motorized mistblower – your

personal safety is at risk.

Never service or store the machine near an open

flame.

Regularly check the fuel tank lid for sealing and

tank ventilation. Only use recommended spark

plugs. Check ignition cable for any damage.

After a running in period of approx. 5 hours, all

accessible screws and nuts (except for carburetor

mixture adjustment needles) have to be checked

and re-tightened if required.

Never operate a motorized mistblower with a

damaged muffler or without muffler (fire risk and

risk of damage to hearing). Do not touch hot

muffler.

5.1 Fuel tap

Remove the fuel cock at regular intervals to clean

the fuel strainer. - Make sure to keep the vent hole

of the fuel tank cap open at all times.

5.2 Formula Tank Lid

Watch seal of the spray tank lid and service by

lubricating the rubber gasket inside the lid. Failing

this, pressure built-up in the container is impaired

and dosage of emission becomes irregular.

5.3 Liquid Tap

Maintain the tap on a regular basis and apply oil or

grease. To disassemble the tap, twist the upper

part 1/4 turn to the left (anti-clockwise). Apply oil or

grease to the valve stem and o-ring, than re-

assemble. Replace o-ring if required.

5.4 Air Filter

The air filter separates and retains dirt before

the air reaches the combustion chamber. This

reduces engine wear.

Regular maintenance increases engine life.

Clogged air filters cause performance loss and

increased fuel consumption. This leads to a higher

toxin level in the exhaust gas and also makes

starting more difficult.

For daily cleaning:

Tap the air filter against an object or use an air

gun.

With heavy dust conditions and for normal weekly

check:

thoroughly clean the filter and replace filter if

damaged.

Cleaning of air filter

Before opening the air filter, close the choke to

prevent dirt entering the carburettor.

For removal of the air filter, remove filter cover

screw and filter cover.

When re-fitting, ensure the filter is positioned and

seated properly.

When the machine is used all day, the air filter

should be cleaned daily. In severe dust conditions

clean more often.

Simply tapping the filter against an object is the

best method of cleaning.

Wash a heavily soiled filter in non-flammable

cleaning solvents (warm soapy water).

Never insert moist or wet foam filters!

Immediately replace damaged filter parts.

Warranty claims cannot be accepted for damaged

engine parts caused by improper care and

maintenance.

5.5 Spark Plug

The correct spark plug with thermal range 145 is

available under the following brands:

BOSCH W8AC

The correct electrode gap is 0.5mm.

Caution: Check the plug after every 50

operating hours and replace if electrodes

are worn.

Fig. 2

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Solo Port 423 Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Solo Port 423

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info