45
Place the second subassembly in the position you can see in the following image, use
the other 2 screws removed earlier (DIN 6921 M6x20mm) to attach the subassembly to
the equipment. Pay special attention to the position of the front and rear rails, as you can
see in the image below, they should be inside the vertical columns of the subassembly. If
you do not, you won't be able to put them in their place afterwards.
Figure 40
Remove the screws and the side member from the first sub-assembly, put the front
and rear limbs in place and replace, this time within the front and rear limbs, the lateral
limb. Fix it again with the screws. Before tightening all the screws well, carefully check the
position of all the parts for maximum perpendicular to each other.
Figure 41
