18
Figure 11 - 3 Position Switch
Attention: all three wires in the power feed cable – ground, neutral and phase –
should be connected. We take no responsibility for any damage resulting from non-
compliance with this warning.
* The electrical components should always be connected to the power supply.
* The cable used for the electrical connection should be silicon-coated and heat-
resistant to 356°F (180°C). If the power feed cable is damaged, it should only be
replaced by a qualified technician.
* You should take care to not lay the cable where it may be crushed.
* The electrical installation should incorporate means to switch the unit off, with a
minimum separation of 0,118 inches (3 mm) between the contacts, pursuant to the
applicable legislation in force
