474216
15
Zoom out
Zoom in
Vorherige Seite
1/32
Nächste Seite
Initial operation
15
Check door end positions
for OPEN + CLOSED
The running path of the drive can be extended or shortened by means
of the guide idlers.
Check whether the door opens and closes completely. If this isn't the case,
then the running path must be adjusted.
1
2
1. Actuate control device (e.g. button, hand-held transmitter, etc.) once.
The door opens to the until the door OPEN end position is reached.
2. Check whether the door reaches the desired end positions.
Adjust the end positions if necessary. See the chapter
“Commissioning – adjusting the door Closed + Open end positions”.
Checking the emergency release
NOTE!
You can activate Backjump for sectional doors or doors
with ceiling guides by means of DIP switch 6; this relieves
the drive and door mechanisms. Simpler actuation of the
emergency release.
V
N
1
FR
O
N
T
VO
R
N
E
1. Close the door with the drive.
2. Pull once on the emergency release (N).
If the emergency release cannot be actuated, loosen the end switch (V)
and push it a bit in direction (1).
3. Open and close the door with the drive. Recheck the emergency release.
Check the force settings
For every run of the door, the controller compares the stored force values
with the actual values required and automatically adjusts the stored values
upon reaching the end position.
Check: See chapter “Care and maintenance/regular testing”.
Programming the hand-held
remote control
NOTE!
Before programming the hand-held transmitter for the rst
time, always clear the radio receiver memory completely.
5
T
2
3.1
3.2
1
7
8
4
5
6
5
3.1
3.2
1
Deleting the radio receiver memory
1. Press and hold the Learn button (1).
After 5 seconds, the LED ashes (3.1 or 3.2).
After another 10 seconds, the LED lights up steadily (3.1 or 3.2).
After a total of 25 seconds, all LEDs light up steadily (3.1 and 3.2).
2. Release the Learn button (1) – the deletion procedure is ended.
Programming the hand-held remote control
1. Press the Learn button (1).
1x for channel 1; the LED (3.1) lights up.
2x for channel 2; the LED (3.2) lights up.
If no code is sent within 10 seconds, the radio receiver switches to
Normal mode.
2. Press the desired hand-held transmitter button (5) until the LED (3.1/3.2)
extinguishes, depending upon which channel has been selected.
LED extinguishes – programming is nished.
The hand-held transmitter has transferred the radio code to the
radio transmitter.
3. For the additional programming of hand-held transmitters, repeat the
steps above. A maximum of 112 memory locations are available for
each radio receiver.
Interrupting the Learn mode:
Press the Learn button (1) until no more LEDs are lit.
Mount the information sign
N
BACK
HINTEN
N
BACK
HINTEN
46
5
0
2V
0
00
-1
7
20
0
6
-0-OC
E
_
R
e
v.A
46
5
0
2V
0
00
-17
20
06
-0-O
C
E
_R
ev
.A
A
B
The information sign concerning the function of the emergency release;
please hang on the emergency release cord.
15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

sommer-marathon-1100sl

Suche zurücksetzen

  • der tohr geht nicht mehr auf auch mit schlüssel nicht Eingereicht am 14-7-2022 10:40

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sommer Marathon 1100SL wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Sommer Marathon 1100SL

Sommer Marathon 1100SL Bedienungsanleitung - Deutsch - 32 seiten

Sommer Marathon 1100SL Bedienungsanleitung - Holländisch - 40 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info