Bedienungsanleitung Sommer Marathon 550SL (Seite 3 von 32) (Englisch)

474214

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Symbols

ATTENTION SYMBOL:

Important safety instructions!

Attention – to ensure personal safety, it is important

to observe all instructions. Save these instructions!

NOTE SYMBOL:

Information, useful advice!

Refers to a respective picture in the introduction or main text.

Safety instructions

General

 These installation and operating instructions must be read, understood

and complied with by persons who install, use or perform maintenance

on the drive.

 Installation, connection and initial commissioning of the drive may only

be carried out by technically knowledgeable persons.

 All lines are to be ﬁ rmly secured, for example, against moving

 Only install the drive on correctly aligned and weight-balanced doors.

An improperly aligned door can cause serious injuries or damage

the drive.

 The manufacturer assumes no liability for injuries, damage or break-

downs that occur due to non-compliance with the installation and

operating instructions.

 Ensure that these installation and operating instructions are kept

in an easily accessible location within the garage.

 Always ensure compliance with accident prevention regulations and

current standards in each respective country.

 Observe and comply with the “ASR A1.7 Technical Regulations

for Workplaces” of the German Committee for Workplaces (ASTA),

which is mandatory for the operator in Germany.

 Always disconnect the mains plug before working on the drive.

 Only use OEM (Original Equipment Manufacturer) spare parts,

accessories and mounting material.

Storage

 The drive must be stored indoors in an enclosed, dry area at a room

temperature of –20 – +50 °C.

 The drive should be stored horizontally.

+50°

20°

Operation

 The drive may only be operated if a non-hazardous force value has

been set. This force value must be set low enough to ensure that

the closing force poses no risk of injury.

 Never put your hand near the door when it is moving or near moving

parts.

 Continuously monitor the door while it is in motion and keep all persons

away from it until the door is completely opened or closed.

 Only pass through the door only once it is completely open.

 Actuating the emergency release can lead to uncontrolled door

movements if springs are weakened or broken, or if the door

has not been optimally weight-balanced.

 There is a risk of persons being crushed or cut by the mechanism

or sharp edges of the door.

 If the garage does not have a separate entrance or the garage door

does not have a built-in slip door, you must install an emergency

release (release lock or Bowden cable) that can be operated from

outside.

Radio remote control

 The remote control must only be used for devices and systems in which

radio interference will not endanger people, animals or objects, or the

risk is reduced by other safety devices.

 The user must be made aware that systems that pose an accident risk

should only be operated – if at all – by remote control if the user can

actually see the door.

 The radio remote control may only be used if the door’s movement

can be watched and no persons or objects are within the range

of movement.

 Store the hand-held transmitter so that unintended operation,

e.g., by children or animals, is impossible.

 The operator of the radio-controlled system is not protected

against interference from other telecommunications equipment or

devices (e.g. radio systems that are being properly operated in the

same frequency range). If substantial interference occurs, please

contact your appropriate telecommunications ofﬁ ce which has radio

interference measuring equipment (radiolocation).

 Do not operate the hand-held transmitter in areas with sensitive radio

communications or systems (e.g. airports, hospitals).

Type plate

 The type plate is located on the controller housing.

 The type plate shows the exact type designation and the date

of manufacture (month/year) of the drive.

Intended use

CAUTION! RISK OF IRREPARABLE DAMAGE TO THE DRIVE!

Do not open or close doors with the drive unless the

counterbalance is properly adjusted (springs tensioned).

Otherwise, you will damage or destroy the motor

(transmission).

CAUTION! RISK OF DEATH!

Remove all cords or straps necessary to operate the door

by hand.

 The drive is intended exclusively to open and close doors. Any other

use does not constitute intended use. The manufacturer accepts no

liability resulting from use other than intended use. The user bears

the sole responsibility for any risk involved. It also voids the warranty.

 Doors automated with a drive must comply with all valid standards and

directives: e.g. EN 12604, EN 12605.

 The drive may only be used if it is in perfect working order and is used

as intended, in conscious observation of safety and hazards and in

accordance with the installation and operating instructions.

 Malfunctions which could affect safety must be corrected immediately.

 The door must be stable and rigid, meaning that it may not bend or

twist when being opened or closed.

 The drive cannot compensate for defects in the door or incorrect

assembly or installation.

 Only use the drive in a dry, non-hazardous area.

 Do not install the drive in areas with a corrosive atmosphere

(e.g. salty air).

General Information

Sommer Marathon 550SL Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sommer Marathon 550SL

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info