474214

Sommer Marathon 550SL Seite 8

8
Zoom out
Zoom in
Vorherige Seite
1/32
Nächste Seite
8
Safety instructions
ATTENTION!
Important instructions for safe installation.
Observe all installation instructions – improper installation
can lead to serious injuries!
ATTENTION!
After installation, it is imperative that you check the drive to
ensure that it has been correctly adjusted and that it reverses
upon contacting a 50 mm high object on the fl oor.
The drive may only be installed, connected and commissioned
by qualifi ed technicians.
Do not move the door if there are people, animals or objects
in the area of movement.
Wear safety glasses when drilling the fastening holes.
Cover the drive during drilling to prevent penetration of dirt.
ATTENTION!
Walls and ceiling must be solid and stable. Only install the
drive on a correctly aligned door. An incorrectly aligned door
could cause serious injury.
Doors must be stable in themselves, since high traction and
compression forces are encountered. Reinforce lighter doors made
of plastic or aluminum if necessary before installation. Ask a specialist
retailer for advice.
Remove or disable door locks.
Use only approved fasteners (e.g. anchor fi ttings, bolts).
The fasteners must be suitable to the material of the ceilings and walls.
Check that the door runs smoothly.
The door must be counterbalanced.
TEST:
Half-open the door by hand. The door must remain in this
position. If the door moves up or down, re-adjust the door
mechanically. Ask a specialist retailer for advice.
Check the distance between the door's highest point (THP, see graphic 8)
and the ceiling. The distance between the THP and the lower edge C must
be between 5 mm and 65 mm; the angle of the door arm must be max. 30°
(see graphic 8). If the distance is less than this, the drive must be moved
back and a longer push rod must be installed. Ask a specialist retailer for
advice.
Door types and accessories *
* Accessories not included in the scope of delivery
12 3
45
No. Door type Accessories
Swinging door No accessories required
Sectional door with single
running rail
Sectional door fi tting
with boomerang *
No. Door type Accessories
Sectional door with double
running rail
Sectional door bracket
without boomerang
Sectional overhead door No accessories required
Up-and-over door Curved arm *
Hinged double door Hinged double door fi tting *
Roller door, side-sectional door Consult your specialist dealer
Tips for installation
• Check the delivery scope components before beginning installation;
this way you save time and unnecessary effort if a part is missing.
• With two persons, installation can be carried out quickly and safely.
• Ensure that the door does not become twisted or jammed in the
running rails.
CHECK:
Open and close the door by hand several times at the location
where the drive is to be installed. If the door can be operated
easily at this location (without exceeding the specifi ed
forces), then the drive can be installed.
Emergency release
In a garage without a separate entrance (e.g. slip doors), the drive's
emergency release must be operable from outside.
Thus, position the emergency release so that it externally accessible;
this can be done with a Bowden cable or an emergency release lock.
For this purpose, Backjump (DIP switch 6 ON) should always be switched
on. Refer to the chapter “Functions and connections – Backjump (DIP 6)”.
Swinging doors
Because the mechanical locking of a door equipped with a drive must
be removed or disabled, depending on the design of the door, it could
be possible to manually raise the door approx. 50 mm. To counteract
this, spring catches can installed to lock the door in addition to the drive.
These spring catches are connected to the drive by means of a locking set;
when opening a door, the spring catches must fi rst be disengaged before
the drive can open the door.
Hinged double door, roller door or side-sectional door
With drives that push one of the previously mentioned doors ahead
(see graphic below), the polarity of wires 12 + 13 must be reversed
on the direct connector. Refer to the chapter “Functions and connections –
24-pole direct connector”.
Installation
… 8 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sommer Marathon 550SL wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Sommer Marathon 550SL

Sommer Marathon 550SL Bedienungsanleitung - Deutsch - 32 seiten

Sommer Marathon 550SL Bedienungsanleitung - Holländisch - 40 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info