680825
87
Zoom out
Zoom in
Vorherige Seite
1/96
Nächste Seite
87
S10564-00001_Rev-A_EN
16. Placing out of operation, storage and disposal
16.1 Placing the operator out of
operation and disassembly
Follow the basic safety instructions listed below.
People under the influence of drugs, alcohol, or
medications that can influence their ability to react may
not work on the operator.
The disassembly of the operator may only be performed
by a qualified specialist.
This installation and operating manual must be read,
understood and complied with by the qualified specialist
who disassembles the operator.
DANGER
Danger if not observed!
If safety instructions are not observed,
serious injury or death may result.
All safety information must be complied
with.
DANGER
Danger due to electric current!
Contact with live parts may result in
electric current owing through the
body.
Electric shock, burns or death will
result.
All disassembly work on electrical
components may only be carried out by
a trained electrician.
The operator must be disconnected
from the mains voltage before
disassembly.
If a battery pack is connected,
disconnect it from the wall control unit.
Then check that the operator is
disconnected from the power supply
and secure it from switching on again.
WARNING
Danger of falling!
Unsafe or defective ladders may tip and
cause serious or fatal accidents.
Use only a non-slip, stable ladder.
Ensure that ladders are safely
positioned.
WARNING
Danger of tripping and falling!
Unsafely positioned parts such as
packaging, operator parts or tools may
cause trips or falls.
Keep unnecessary items away from
the disassembly area.
Place all parts where no persons are
likely to trip or fall over them.
General workplace guidelines must be
observed.
WARNING
Danger due to optical radiation!
Looking into an LED at short range for
an extended period may cause optical
glare.
This may temporarily reduce vision. This
may cause serious or fatal accidents.
Do not look directly into a LED.
WARNING
Danger due to hot surfaces!
After frequent operation parts of the
carriage or the control unit may become
hot. If the cover is removed and hot
parts are touched, they may cause
burns.
Allow the operator to cool before
removing the cover.
87

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sommer S 9060 Tiga wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Sommer S 9060 Tiga

Sommer S 9060 Tiga Bedienungsanleitung - Deutsch - 96 seiten

Sommer S 9060 Tiga Bedienungsanleitung - Holländisch - 96 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info