Bedienungsanleitung Sommer S 9080 base plus (Seite 72 von 80) (Englisch)

680554

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

46900V001_Rev-D_EN

16. Troubleshooting

16.4 Troubleshooting table

Problem Possible cause Test/check Remedy

The operator opens

the door when the

transmitter or control

device is actuated but

does not close it.

• Photocell and safety

device interrupted

• Check photocell and safety

devices

• Remove obstacle

• The photocell must be aligned

• Have it checked and replaced by a

qualiedspecialist

• Automatic closing

function activated

• Wait to see whether the

operator starts automatically

after 30 seconds

• Automatic closing function

deactivated

• Have the cause corrected by a

trained electrician

Operator cannot be

operated with the

control device.

• No power • Check power supply • Check the power socket with a

different device, for example by

plugging in a lamp

• Limit switch on motor

carriage defective

• Unlock operator and push

motor carriage to the centre of

the track

• Lock operator

• Actuate transmitter

• If the operator still closes the

door but does not open it,

the limit switch is defective

• Have the limit switch replaced by a

qualiedspecialist

• The operator was

unlocked by the

emergency release

mechanism

• Check that the door can be

moved manually

• Pull the emergency release handle

to lock the operator

• Control device

incorrectly connected to

the operator

• Check function of operator

with a transmitter

• Check wiring, correct if necessary

• Transmitter defective • Operator cannot be started

with the transmitter

• Check transmitter power supply

• If necessary, replace the battery of

the transmitter

• If necessary, replace the

transmitter with a new one

• Operator defective • Operator cannot be started

with the transmitter or the

connected control device

• Have operator repaired or

replacedbyaqualiedspecialist

• Electrical supply voltage

outside the approved

range

• Have the mains voltage

checked by a trained

electrician

• Have the cause corrected by a

trained electrician

When a button on

the transmitter is

pressed, the door

does not open or

close.

• Transmitter not

programmed

• Radio LED does not light

up when the transmitter is

operated

• Programme transmitter

• Battery in the

transmitterisat

• Replace the battery of the

transmitter

• Transmitter defective • LED on transmitter does not

light up

• Replace transmitter

Radio command

cannot be

programmed.

• Memory full • All four LEDs for radio blink

cyclically for about 3 seconds

• Memory full, see Chapter

"10.6 Information on Memo"

and "10.8 Deleting a transmitter

button from the radio channel"

MEMO Identier error • Incorrect MEMO • All four LEDs blink cyclically

for a short time and then

go out for a long time. The

operator lighting of the motor

carriage blinks 4 times short

and 4 times long.

• Disconnect operator from the

power supply, unplug Memo,

re-supply operator with power

MEMO device type

error

• System error • All four LEDs blink cyclically

for a long time and then go

out for a short time. If voltage

is present, the operator

lighting of the motor carriage

blinks an additional four times.

• Memo can be deleted via

the Radio button, see Chapter

"10.8 Deleting a transmitter

button from the radio channel"

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sommer S 9080 base plus Seite 72

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sommer S 9080 base plus

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info