Bedienungsanleitung Sommer S 9110 pro plus (Seite 78 von 88) (Englisch)

680778

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

S10931-00001_Rev-D_EN

16. Troubleshooting

16.4 Troubleshooting table

Problem Possible cause Test/check Remedy

The operator opens

the door when the

transmitter or command

device is actuated but

does not close it.

• Photocell and safety

device interrupted

• Check photocell and safety

devices

• Remove obstacle

• The photocell must be aligned

• If necessary, have it checked and

replacedbyaqualiedspecialist

• Automatic closing

function activated

• Wait to see whether the

operator starts automatically

after 30 seconds

• Automatic closing function

deactivated

• Have the cause corrected by

a trained electrician

Operator cannot be

operated with the

command device.

• No power • Check power supply • Check the power outlet with

a different device, for example

by plugging in a lamp

• Limit switch on motor

carriage defective

• Unlock operator and push

motor carriage to the centre

of the track

• Lock operator

• Actuate transmitter

• If the operator still closes

thedoor but does not open it,

the limit switch is defective

• Have the limit switch replaced by

aqualiedspecialist

• The operator was

unlocked by the

emergency release

mechanism

• Check that the door can be

moved manually

• Pull the emergency release handle

to lock the operator

• Control device

incorrectly connected to

the operator

• Check function of operator

with a transmitter

• Check wiring and correct if

necessary

• Membrane keypad

of the wall unit is not

working

• Check cable • Plug in cable

• If necessary, replace wall control

unit cover

• Transmitter defective • Operator cannot be started

with the transmitter

• Check transmitter power supply

• If necessary, replace the battery

of the transmitter

• If necessary, replace the

transmitter with a new one

• Operator defective • Operator cannot be started

with the transmitter or the

connected command device

• Have operator repaired or

replacedbyaqualiedspecialist

• Electrical supply voltage

outside the approved

range

• Have the mains voltage

checked by a trained

electrician

• Have the cause corrected by

a trained electrician

When a button on the

transmitter is pressed,

the operator does not

open or close the door.

• Transmitter not

programmed

• Radio LED does not light

up when the transmitter is

operated

• Programme transmitter

• Battery in the

transmitterisat

• Replace the battery of the

transmitter

• Transmitter defective • LED on transmitter does not

light up

• Replace transmitter

Radio command cannot

be programmed

• Memory full • AllfourLEDsforradioash

cyclically for about 3 seconds

• Memory full, see Chapter

"10.6 Information on Memo"

and "10.8 Deleting a transmitter

button from the radio channel"

MEMOIdentiererror

• Incorrect MEMO • AllfourLEDsforradioash

cyclically for a short time and

then go out for a long time.

The operator lighting of the

motorcarriageashes4times

short and 4 times long.

• Disconnect operator from the

power supply, unplug Memo,

re-supply operator with power

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sommer S 9110 pro plus Seite 78

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sommer S 9110 pro plus

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info