Bedienungsanleitung Sommer S 9110 pro (Seite 70 von 88) (Englisch)

680783

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

S10931-00001_Rev-D_EN

14. Operation

14.4 Testing obstacle detection

The operator stops and reverses slightly if it encounters

an obstacle. This prevents injury and damage to

property. The door will be partially or completely opened

depending on the setting.

The partial reversion is pre-set at the factory.

Full reversion can be set via SOMlink and a WiFi-enabled

device.

INFORMATION

Reversing: The operator stops when it

hits an obstacle. Then the operator moves

slightly in the opposite direction to release

the obstacle.

In the automatic closing function, the door

opens completely.

The following safety devices are installed to detect

obstacles:

• photocell (object protection)

• safety contact strips (personal protection)

• obstacle detection of the operator (personal

protection)

Here, also note chapter "15. Maintenance and care."

14.5 Power-saving mode

To save energy, the operator control unit switches to

power-saving mode after the factory-specified period.

Connected accessories are deactivated and then

reactivated at the next command from a button or radio.

Connected accessories may include: photocell, safety

contact strip and external radio receiver.

Because external radio receivers are deactivated in

power-saving mode, they cannot receive commands from

the remote control and send them to the operator.

Set DIP switch 3 to "ON" to power the entire system

continuously. Power-saving mode is deactivated.

DIP switch on

wall unit

ON OFF

1234

• Continuous

power to the

complete

system

activated

• Power-saving

mode activated

INFORMATION

The factory-set period before the control

unit switches to power-saving mode is

20 seconds. This value cannot be changed.

14.6 In the event of a power failure

The programmed force values and end positions of the

operator remain saved in the event of a power failure.

After the power supply has been restored, the first

movement of the operator after a pulse is always door

OPEN.

Also see the information on the emergency release

in chapter "11.8 Installing and removing the

accumulator" and "14.7 Function of the emergency

release."

14.7 Function of the emergency release

In the event of a power failure, the door can be opened

from the inside using a mechanical emergency release.

Observe in particular the following safety instructions for

this chapter.

WARNING

Danger for trapped persons!

Persons may be trapped inside the

garage. If trapped persons cannot free

themselves, severe injury or death may

result.

► Test the operation of the emergency

release regularly from inside and if

necessary, also from outside.

► You must have faults repaired

professionally without delay.

WARNING

Danger due to falling parts of

doors!

If the emergency release is actuated,

weak or broken springs may cause

the door to close suddenly and

unexpectedly. This may cause serious

or fatal injury.

► The emergency release should be used

only with the door closed.

► Use the emergency release with great

caution if the door is open.

► Keep persons and animals clear of

the range of movement of the door.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sommer S 9110 pro Seite 70

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sommer S 9110 pro

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info