Threading in the power and antenna cables
Fig. 11: Threading in the power and antenna cables
5. From below, thread the power cable and – if
required – the antenna cable through the cut-
out in the threaded rod , through the opening
in the baseplate and through the cut-out in
the protective cover with cable opening .
Attaching the stand tube
Fig. 12: Attaching the stand tube
6. Position the stand tube with the milled
opening facing upwards and place it on the
threaded rod .
7. Make sure that the milled opening in the stand
tube is on the same side as the cut-outs for
cable routing underneath the tube.
i
The stand tube
acts as a cable duct for the
power and antenna cables.
8. Route the power cable and, if required, the
antenna cable through the
milled
opening in the
stand tube
.
9. Place the protective cover without cable
opening on the threaded rod .
© sonoro audio GmbH 2016 85
