Bedienungsanleitung Sonoro iElements (Seite 46 von 191) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Norwegisch)

468984

Zoom out

Zoom in

Vorherige Seite

1/191

Nächste Seite

English

8.2 Alarm

Your iElements can wake you up with a radio station or a pleasant alarm tone. You can set

the volume of the alarm and use the so-called snooze function.

You can set the alarm when the iElements is switched on as well as when the device is

switched off. In both cases press the menu button and then use the << and >> buttons to

navigate through the options until ALARM appears on the display. Conrm your selection by

pressing the menu button.

Now you can activate the alarm (ALM ON) or deactivate it (ALM OFF) with the + and –

buttons and conrm your selection with the menu button. If you select ALM OFF, the setting is

cancelled. You can recognise an active alarm by the small alarm symbol on the display.

When you have selected ALM ON, you can set the wake-up time. This is selected in the same

way as setting the display time with the +/- and <</>> buttons. Conrm your selection with

the menu button.

SOURCE then appears on the display and you can decide which signal you would like to be

woken by. The frequency ranges FM and AM as well as an alarm tone (BEEP) are available.

Make your selection with the << and >> buttons and conrm it with the menu button. If you

select a radio station, you can use the stations you have saved in the presets. Use the + and

- buttons to select from the 10 memory presets 0…9 for each frequency band.

VOLUME then appears on the display and you can select the alarm volume of your signal

source with the + and – buttons. As soon as the alarm starts, the volume is slowly increased

until it reaches the level you have selected. When you conrm your selection with the menu

button, the alarm has been set. ALARM ON appears on the display.

NOTE!

When setting the alarm time, please pay attention to the selected time format.

You can recognise an active alarm by the alarm symbol on the display. Before

using this function for the rst time, test the different alarm volumes to nd a

level that is suitable for you. If you have connected a device to the

headphones socket, please note that the alarm tone will only be output

through this device. This means, for example, that you may not be able to

hear the alarm if the headphones have slipped. Please make sure that you

switch off the alarm, for example, if you go on holiday.

You can switch off an active alarm by pressing the menu button for approximately two

seconds. The alarm will stop and the small alarm symbol on the display stops ashing.

If you want to temporarily suppress an active alarm rather than turning it off, you can use the

snooze function. Briey press the menu button once when the alarm is activated. SNOOZE

then appears on the display and you can use the + and – buttons to set the number of

minutes after which the alarm should be switched on again. The default setting is 5 minutes.

Once you have made your selection, please conrm it with the menu button. The small alarm

symbol on the display continues to ash and is reactivated after the time you have set. If you

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sonoro iElements Seite 46

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info