49839
90
Zoom out
Zoom in
Vorherige Seite
1/132
Nächste Seite
90
To write the RC time code from the
end of the RC time code recorded
portion
Rewind the tape to the portion on which the RC
time code has been written and set the camcorder
to playback pause mode. Then follow steps 3 and
4 above. The RC time code is written
continuously.
Notes on writing the RC time code
The RC time code writing stops when:
you press TIME CODE WRITE again before
starting playback.
you press INDEX before starting playback.
you change from playback mode to another
mode.
When you are writing the RC time code from
the middle of a tape without the time code
written, writing starts several frames before the
current picture.
If you write the RC time code on a recorded
tape, the Data Code is erased.
You cannot write the RC time code on the tape
that is recorded in LP mode. Though you can
write the RC time code on a tape recorded both
in LP mode and SP mode, the RC time code
written in LP mode, however, may not be read
correctly.
You cannot write the RC time code on an
NTSC-recorded tape.
While the RC time code is being erased, the
sound cannot be heard and a black band
appears at the bottom of the picture. This will
not affect the recorded sound or picture.
Note on --:--:--:-- indicator
The --:--:--:-- indicator appears during playback
if:
nothing is recorded.
the RC time code is unreadable because of the
damage of the tape or because of the noise.
you recorded using another VCR without RC
time code function.
you erase the index signal or make PCM after
recording on another VCR in the portion on
which the RC time code is written.
In this case, we recommend you to rewrite the
RC time code.
Для записи временного кода RC от
конца записанной части с временным
кодом RC
Перемотайте ленту назад до части, на
которой был записан временной код RC, и
установите видеокамеру на режим паузы
воспроизведения. Затем следуйте
вышеописанным пунктам 3 и 4. Временной
код RC будет записан без перерыва.
Примечания к записи временного кода RC
Запись временного кода RC отменяется,
когда:
Вы нажимаете TIME CODE WRITE снова
до начала воспроизведения.
Вы нажимаете INDEX до начала
воспроизведения.
Вы изменяете режим воспроизведения на
другой режим.
Если Вы записываете временной код RC с
середины ленты, на которой не записан
временной код RC, запись временного кода
начнется на несколько кадров раньше
текущего изображения.
Если Вы записываете временной код RC на
записанную ленту, то код данных стирается.
Вы не можете записать временной код RC
на ленту, записанную в режиме LP.
Несмотря на то, что Вы можете записать
временной код RC на ленту, записанную и в
режиме LP и в режиме SP, временной код
RC, записанный в режиме LP, все равно не
может быть считан правильно.
Вы не можеет записать временной код RC
на ленте, записанной в системе NTSC.
Во время стирания временного кода RC
звук прослушиваться не может, и черная
полоса появляется внизу изображения. Это
не будет влиять на записанные звук или
воспроизведение.
Примечание к индикатору --:--:--:--
Индикатор --:--:--:-- появляется во время
воспроизведения, если:
ничего не записано.
временной код RC не считывается из-за
повреждения ленты или из-за помех.
Вы произвели запись с использованием
другого КВМ без функции временного кода
RC.
Вы стираете индексный сигнал или
выполняете РСМ после записи на другом
КВМ в части, на которой был записан
временной код RC.
В таком случае мы рекомендуем Вам
перезаписать временной код RC.
Writing the RC Time code on a
recorded tape
Запись временного кода RC на
записанной ленте
90

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sony CCD-TR3400E wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Sony CCD-TR3400E

Sony CCD-TR3400E Bedienungsanleitung - Deutsch, Französisch - 132 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info