Bedienungsanleitung Sony CCD-TR718E (Seite 74 von 112) (Schwedisch)

49971

Zoom out

Zoom in

Vorherige Seite

1/112

Nächste Seite

If you run into any problem using your camcorder, use the following table to troubleshoot the

problem. If the problem persists, disconnect the power source and contact your Sony dealer or local

authorized Sony service facility. If “C:ss:ss” appears in the viewfinder or the display window, the

self-diagnosis display function has worked. See page 77.

In the recording mode

Symptom Cause and/or Corrective Actions

• The POWER switch is set to OFF (CHARGE) or PLAYER.

c Set it to CAMERA. (p. 25)

• The tape has run out.

c Rewind the tape or insert a new one. (p. 23, 36)

• The write-protect tab is set to expose the red mark.

c Use a new tape or slide the tab. (p. 23)

• The tape is stuck to the drum (moisture condensation).

c Remove the cassette and leave your camcorder for at least 1

hour to acclimatize. (p. 91)

• While being operated in CAMERA mode, your camcorder has

been in the standby mode for more than 5 minutes.

c Set the POWER switch to OFF (CHARGE) and then to

CAMERA again. (p. 25)

• The battery pack is dead or nearly dead.

c Install a fully charged battery pack. (p. 14, 15)

• The viewfinder lens is not adjusted.

c Adjust the viewfinder lens. (p. 27)

• FOCUS is set to MANUAL.

c Set it to AUTO. (p. 50)

• Shooting conditions are not suitable for autofocus.

c Set FOCUS to MANUAL to focus manually. (p. 50)

• The video heads may be dirty.

c Clean the heads using the Sony V8-25CLD cleaning cassette

(optional). (p. 92)

• The contrast between the subject and background is too high.

This is not a malfunction.

• This is not a malfunction.

• If 10 minutes elapse after you set the POWER switch to

CAMERA or DEMO MODE is set to ON in the menu settings

without a cassette inserted, your camcorder automatically

starts the demonstration.

c Insert a cassette and the demonstration stops.

You can also cancel DEMO MODE. (p. 67)

• NIGHTSHOT is set to ON.

c Set it to OFF. (p. 31)

• NIGHTSHOT is set to ON in a bright place.

c Set it to OFF, or use the NightShot function in a dark place.

(p. 31)

• The backlight function is working.

c Cancel it. (p. 30)

— Troubleshooting —

English

Types of trouble and their solutions

START/STOP does not operate.

The power goes off.

The image on the viewfinder screen

is not clear.

The autofocusing function does not

work.

The x indicator flashes in the

viewfinder.

A vertical band appears when you

shoot a subject such as lights or a

candle flame against a dark

background.

A vertical band appears when you

shoot a very bright subject.

An unknown picture is displayed in

the viewfinder.

The picture appears too bright, and

the subject does not appear in the

viewfinder.

The picture is recorded in incorrect or

unnatural colours.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony CCD-TR718E Seite 74

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sony CCD-TR718E

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info