Bedienungsanleitung Sony CDX-MR60UI (Seite 25 von 172) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

548300

Zoom out

Zoom in

Vorherige Seite

1/172

Nächste Seite

Supplied accessory:

Card remote commander: RM-X151

Parts for installation and connections (1 set)

Optional accessories/equipment*:

Marine remote commander: RM-X60M,

RM-X11M

Rotary commander: RM-X4S

BUS cable (supplied with an RCA pin cord):

RC-61 (1 m), RC-62 (2 m)

CD changer (6 discs): CDX-T69

Source selector: XA-C40

AUX-IN selector: XA-300

USB connection cable for iPod: RC-100IP

* Accessories/equipment other than the marine

remote commander RM-X60M/X11M are not

waterproof. Do not subject them to water.

Your dealer may not handle some of the above listed

accessories. Please ask the dealer for detailed

information.

Design and specifications are subject to change

without notice.

Troubleshooting

The following checklist will help you remedy

problems you may encounter with your unit.

Before going through the checklist below, check the

connection and operating procedures.

If the problem is not solved, visit the following

support site.

• Halogenated flame retardants are not used in the

certain printed wiring boards.

• Halogenated flame retardants are not used in

cabinets.

• Packaging cushions are made from paper.

General

No power is being supplied to the unit.

• Check the connection or fuse.

• If the unit is turned off and the display disappears, it

cannot be operated with the remote commander.

t Turn on the unit.

The power antenna (aerial) does not extend.

The power antenna (aerial) does not have a relay box.

No sound.

• The ATT function is activated, or the Telephone ATT

function (when the interface cable of a telephone is

connected to the ATT lead) is activated.

• The position of the fader control “FAD” is not set for

a 2-speaker system.

No beep sound.

• The beep sound is canceled (page 18).

• An optional power amplifier is connected and you are

not using the built-in amplifier.

The contents of the memory have been erased.

• The RESET button has been pressed.

t Store again into the memory.

• The power supply lead or battery has been

disconnected or it is not connected properly.

Stored stations and correct time are erased.

The fuse has blown.

Makes noise when the position of the ignition

is switched.

The leads are not matched correctly with the boat’s

accessory power connector.

During playback or reception, demonstration

mode starts.

If no operation is performed for 5 minutes with

“DEMO-ON” set, demonstration mode starts.

tSet “DEMO-OFF” (page 18).

The display disappears from/does not appear

in the display window.

• The dimmer is set “DIM-ON” (page 18).

• The display disappears if you press and hold (OFF).

t Press and hold (OFF) on the unit until the

display appears.

• The connectors are dirty (page 23).

continue to next page t

Support site

http://support.sony-europe.com

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony CDX-MR60UI Seite 25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info