Bedienungsanleitung Sony Cyber-SHOT DSC-N1 (Seite 122 von 132) (Englisch)

104688

122

Zoom out

Zoom in

Vorherige Seite

1/132

Nächste Seite

122

Precautions

x Do not leave the camera in the

following places

• In an extremely hot place

In places such as in a car parked in the sun, the

camera body may become deformed and this

may cause a malfunction.

• Under direct sunlight or near a heater

The camera body may become discolored or

deformed, and this may cause a malfunction.

• In a location subject to rocking vibration

• Near strong magnetic place

• In sandy or dusty places

Be careful not to let sand or dust get into the

camera. This may cause the camera to

malfunction, and in some cases this malfunction

cannot be repaired.

x On carrying

Do not sit down in a chair or other place with the

camera in the back pocket of your trousers or

skirt, as this may cause malfunction or damage the

camera.

x On cleaning

Cleaning the LCD screen

If fingerprints or dust make the LCD screen dirty,

it is recommended you use a soft cloth to clean it.

When you use the LCD Cleaning Kit (not

supplied), do not apply the cleaning liquid directly

to the LCD screen. Use cleaning paper moistened

with the liquid.

Cleaning the lens

Wipe the lens with a soft cloth to remove

fingerprints, dust, etc.

Cleaning the camera surface

Clean the camera surface with a soft cloth slightly

moistened with water, then wipe the surface with

a dry cloth. Do not use the following as they may

damage the finish or the casing.

• Chemical products such as thinner, benzine,

alcohol, disposable cloths, insect repellent,

sunscreen or insecticide, etc.

• Do not touch the camera with the above on your

hand.

• Do not leave the camera in contact with rubber

or vinyl for a long time.

x On operating temperatures

Your camera is designed for use under the

temperatures between 0°C and 40°C (32°F and

104°F). Shooting in extremely cold or hot places

that exceed this range is not recommended.

x On moisture condensation

If the camera is brought directly from a cold to a

warm location, moisture may condense inside or

outside the camera. This moisture condensation

may cause a malfunction of the camera.

Moisture condensation occurs easily

when:

• The camera is brought from a cold location such

as a ski slope into a warmly heated room.

• The camera is taken from an air-conditioned

room or car interior to the hot outdoors, etc.

How to prevent moisture condensation

When bringing the camera from a cold place to a

warm place, seal the camera in a plastic bag and

allow it to adapt to conditions at the new location

over about an hour.

If moisture condensation occurs

Turn off the camera and wait about an hour for the

moisture to evaporate. Note that if you attempt to

shoot with moisture remaining inside the lens, you

will be unable to record clear images.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony Cyber-SHOT DSC-N1 Seite 122

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sony Cyber-SHOT DSC-N1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info