Bedienungsanleitung Sony DAR-X1R (Seite 3 von 623) (Englisch, Spanisch, Spanisch, Polnisch, Schwedisch)

60938

Zoom out

Zoom in

Vorherige Seite

1/623

Nächste Seite

Precautions

On safety

Should any solid object or liquid fall

into the cabinet, unplug the recorder

and have it checked by qualified

personnel before operating it any

further.

When disconnecting the mains

leads, do not touch the metallic part

of the jacks or plugs.

About the hard disk drive

The hard disk has a high storage

density, which enables long

recording durations and quick

access to the written data. However,

it can easily be damaged by shock,

vibration or dust, and should be kept

away from magnets. To avoid losing

important data, observe the

following precautions.

• Do not apply a strong shock to the

recorder.

• Do not place the recorder in a

location subject to mechanical

vibrations or in an unstable

location.

• Do not place the recorder on top of

a hot surface, such as a VCR or

amplifier (receiver).

• Do not use the recorder in a place

subject to extreme changes in

temperature (temperature gradient

less than 10 °C/hour).

• Do not move the recorder with its

mains lead connected.

• Do not disconnect the mains lead

while the power is on.

• When disconnecting the mains

lead, turn off the power and

make sure that the hard disk

drive is not operating (the clock

is displayed in the front panel

display for at least 30 seconds

and all recording or dubbing has

stopped).

• Do not move the recorder for

one minute after you have

unplugged the mains lead.

• Do not attempt to replace or

upgrade the hard disk by yourself,

as this may result in malfunction.

If the hard disk drive should

malfunction, you cannot recover lost

data. The hard disk drive is only a

temporary storage space.

About repairing the hard disk

drive

• The contents of the hard disk drive

may be checked in case of repair

or inspection during a malfunction

or modification. However, the

contents will not be backed up or

saved by Sony.

• If the hard disk needs to be

formatted or replaced, it will be

done at the discretion of Sony. All

contents of the hard disk drive will

be erased, including contents that

violate copyright laws.

On power sources

• The system is not disconnected

from the AC power source (mains)

as long as it is connected to the

wall outlet, even if the system

itself has been turned off.

• If you are not going to use the

system for a long time, be sure to

disconnect the system from the

wall outlet. To disconnect the AC

power cord (mains lead), grasp the

plug itself; never pull the cord.

• Before disconnecting the AC

power cord (mains lead), check

that the recorder’s hard disk is not

operating (recording or dubbing)

on the front panel display.

On placement

• Place the recorder in a location

with adequate ventilation to

prevent heat build-up in the

system.

• At high volume, over long periods

of time, the cabinet becomes hot to

touch. This is not a malfunction.

However, touching the cabinet

should be avoided. Do not place

the system in a confined space

where ventilation is poor as this

may cause overheating.

• Do not block the ventilation holes

for the cooling fan by putting

anything on the system. The

system is equipped with a high

power amplifier. If the ventilation

holes are blocked, the system can

overheat and malfunction.

• Do not place the system on a soft

surface such as a rug that might

block the ventilation holes.

• Do not place the system in a

confined space such as a bookshelf

or similar unit.

• Do not place the system in a

location near heat sources, or in a

place subject to direct sunlight,

excessive dust, or mechanical

shock.

• Do not place the system in an

inclined position. It is designed to

be operated in a horizontal

position only.

• Keep the recorder and discs away

from equipment with strong

magnets, such as microwave

ovens, or large loudspeakers.

• Do not put any objects on the

recorder as they may fall, damage

the surface, or cause malfunction.

• If the system is brought directly

from a cold to a warm location,

moisture may condense inside the

system and cause damage to the

lenses. When you first install the

system, or when you move it from

a cold to a warm location, wait for

about 30 minutes before operating

the system.

On recording

Make trial recordings before making

the actual recording.

On compensation for lost

recordings

Sony is not liable and will not

compensate for any lost recordings

or relevant losses, including when

recordings are not made due to

reasons including recorder failure,

or when the contents of a recording

are lost or damaged as a result of

recorder failure or repair undertaken

to the recorder. Sony will not

restore, recover, or replicate the

recorded contents under any

circumstances.

,continued

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony DAR-X1R Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sony DAR-X1R

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info