Bedienungsanleitung Sony dav dz680 (Seite 98 von 124) (Englisch)

160601

Zoom out

Zoom in

Vorherige Seite

1/124

Nächste Seite

Troubleshooting

If you experience any of the following difficulties while using the system, use this troubleshooting

guide to help remedy the problem before requesting repairs. Should any problem persist, consult your

nearest Sony dealer.

Note that if service personnel changes some parts during repair, these parts may be retained.

When you install the S-AIR sub unit (optional), in the event of a problem with the S-AIR function, have

a Sony dealer check the entire system together (main unit and S-AIR sub unit).

Power

Picture

Symptom Remedy

The power is not turned on. • Check that the AC power cord (mains lead) is connected securely.

•Press "/1 after “STANDBY” disappears from the front panel display.

If “PROTECTOR” and “PUSH

POWER” appear alternately in

the front panel display.

Press "/1 to turn off the system, and check the following items after

“STANDBY” disappears.

• Are the + and – speaker cords short-circuited?

• Are you using only the specified speakers?

• Is anything blocking the ventilation holes of the system?

• After checking the above items and fixing any problems, turn on the system. If

the cause of the problem cannot be found even after checking all the above

items, consult your nearest Sony dealer.

Symptom Remedy

There is no picture. • The SCART (EURO AV) cable is not connected securely.

• The SCART (EURO AV) cable is damaged.

• The unit is not connected to the correct EURO AV T OUTPUT (TO TV) jack

(page 23).

• The video input on the TV is not set so that you can view pictures from the

system.

• Check the output method on your system (page 23).

• Re-connect the connecting cord securely.

• The unit is connected to an input device that is not HDCP (High-bandwidth

Digital Content Protection) compliant (“HDMI” on the front panel does not

light up) (page 23).

• If the HDMI OUT jack is used for video output, change the type of video signal

output from the HDMI OUT jack. It may solve the problem (page 30).

Connect the TV and the unit using a video jack other than the HDMI OUT, and

switch the TV’s input to the connected video input so that you can see the on-

screen displays. Change the type of video signal output from the HDMI OUT

jack, and switch the TV’s input back to HDMI. If the picture still does not

appear, repeat the Steps and try other options.

• If you are using the “DMPORT” function, the video signal is output from the

EURO AV T OUTPUT (TO TV) jack only.

Picture noise appears. • The disc is dirty or flawed.

• If the signal from the EURO AV T OUTPUT (TO TV) jack is distorted,

change the type of video signal output from the HDMI OUT jack by setting

[HDMI RESOLUTION] in [HDMI SETUP] to [720 × 480p]

* (page 30).

* Depending on the area, [720 × 480/576p] may appear.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony dav dz680 Seite 98

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sony dav dz680

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info