Bedienungsanleitung Sony dhc md 333 (Seite 54 von 60) (Englisch, Französisch)

157962

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

•Connect the sound source properly.

•A pre-recorded MD is in the deck.

Replace the disc with a recordable MD.

•Replace the disc with a recordable MD

that has sufficient time remaining or erase

unnecessary tracks.

•The mains lead was unplugged or a

power interruption occurred during

recording. Start recording over from the

beginning.

“END” is displayed.

•You have reached the end of the MD.

Press MD/CD =0 to return to the

beginning of the MD.

“Level Over” appears during analogue

recording.

A strong signal was input during

recording in the TAPE function. When

the sound is distorted, reduce the

recording level, then re-record. If

distortion may occurs:

1 Stop play or turn off the power of the

other component connected to the TAPE

input.

“Level Over” disappear.

2 Press EDIT on the remote during

recording or pause.

3 Press +/– on the remote.

“Attenuate ?” appears.

4 Press ENTER/YES on the remote.

“Attenuate ON ?” appears.

5 Press ENTER/YES again.

“ATT” appears.

6 Turn on the power of the other

component connected to the TAPE input

and continue recording or start recording

over from the beginning.

To cancel the setting, select “Attenuate

OFF ?” in step 4.

Tuner

Severe hum or noise (“TUNED” or

“STEREO” flashes in the display.).

•Adjust the aerial.

•The signal strength is too weak. Connect

an external aerial.

•Make sure the aerial is connected

properly.

•You cannot fold or roll up the aerial.

•The FM aerial is split in two.

Repair or replace with a new one.

•The AM aerial wire is detached from the

stand.

CD Player

The CD tray does not close.

•The CD is not placed properly.

The CD will not eject.

• The CD has tape, seals, or paste on it.

The CD will not play.

•Press CD 6 to check the CD placed.

When you listening to the radio and the

disc tray is open, the CD indicator is lit

red, then the CD is not placed.

•The CD is dirty.Clean the CD with a

cleaning cloth.

•The face of the CD is scratched. Exchange

the CD.

•The CD is inserted label side down.

•Moisture condensation has built up.

Remove the CD and leave the system

turned on for about 2 hours until the

moisture evaporates.

Play does not start from the first track.

•The player is in programme or shuffle

mode. Press PLAY MODE repeatedly

until “SHUFFLE” or “PGM” disappears.

“OVER” is displayed.

•You have reached the end of the CD.

Press MD/CD =0 to return to the

beginning of the CD.

MD Deck

The controls do not work.

•The MD is dirty or scratched. (“Disc

Error” appears.) Replace the MD with a

new one.

The MD will not play.

•Moisture condensation has built up.

Remove the MD and leave the system

turned on for several hours until the

moisture evaporates.

•Insert the MD in the direction of the

arrow.

•Nothing is recorded on the MD.

Recording is not possible.

•The MD is protected against erasure.

(“MD Protected” appears.) Slide the tab

to close the slot (see page 28).

Troubleshooting (continued)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony dhc md 333 Seite 54

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sony dhc md 333

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info