103
DSC-L1 2-186-455-11(1) [OpenType FONT]
Troubleshooting
Symptom Cause/Solution
You cannot perform other operations
when printing is stopped.
• The printer is performing the printing stop processing, so wait for this processing to finish. (This
processing may take some time depending on the printer.)
Others
Symptom Cause/Solution
A slight rattling noise is heard from
inside your camera when you move
the camera.
• Linear mechanisms are used for some of the lens functions of your camera. This is not a
malfunction.
Your camera does not work. • You are not using an “InfoLITHIUM” battery pack. Use an “InfoLITHIUM” battery pack (page
118).
• The battery level is low. (The indicator appears.) Charge the battery pack (page 13).
• Connect the AC Adaptor securely to the DC IN jack of your camera and to a wall outlet (wall socket)
(page 16).
The power is on, but the camera does
not work.
• The built-in microcomputer is not working properly. Disconnect, and then, after one minute,
reconnect all power sources and turn on the camera. If this does not work, press the RESET button
inside the battery/“Memory Stick Duo” cover with a fine-tipped object, then turn the power on again.
(This will clear the date and time settings, etc.) (page 95)
You cannot identify an indicator on
the screen.
• Check the indicator (pages 121 to 124).
The lens gets fogged. • Moisture condensation has occurred. Turn off the camera and leave for about an hour at room
temperature for the moisture to evaporate before use (page 116).
The camera becomes warm when you
use it for the long time.
• This is not a malfunction.
The lens does not move when you
turn off the camera.
• The battery pack is discharged. Replace the battery pack with a charged battery pack (page 13) or
use the AC Adaptor (page 16).
