59498
86
Zoom out
Zoom in
Vorherige Seite
1/159
Nächste Seite
86
For details on the operation
1
page 80
Recording menu 2
The default settings are marked with .
Reduces the red-eye phenomenon by providing low-flash light a few times before shooting
when using the flash.
Red-Eye reduction is available only with the built-in flash. (When using an external flash (not supplied),
the red-eye phenomenon rarely occurs.)
You can select the flash control mode to set the amount of flash light.
ADI: stands for “Advanced Distance Integration”
P-TTL: stands for “Pre-flash, Through the lens”
When the distance between the subject and the external flash (not supplied) cannot be determined,
(wireless flash shooting using an external flash (not supplied), shooting with an off-camera flash using a
cable, shooting with a macro twin flash or ring light, etc.) the camera automatically selects Pre-flash TTL
mode.
Select [Pre-flash TTL] in the following cases, as the camera cannot obtain accurate distance information
with ADI flash.
A wide panel is attached to the HVL-F36AM flash.
A diffuser is attached to the surface of the flash.
A filter with an exposure factor, such as an ND filter, is used.
A close-up lens is used.
ADI flash is only available in combination with the lens that is provided with a distance encoder. To
determine the lens is equipped with a distance encoder, refer to the operating instructions supplied with
the lens.
When the mode dial is set to AUTO, P, or Scene Selection, the flash mode is set to autoflash
(default setting) automatically. When the flash is pulled up, if you want to make sure the flash
fires without fail, you can set it to Fill-flash. In either case, you can change the flash mode
with the function dial and the Fn button.
Red eye
On Reduces the red-eye phenomenon.
Off Does not use Red-Eye Reduction.
Flash control
ADI flash A pre-flash is fired right before shooting, and the camera sets
the amount of flash light by measuring the amount of
reflected light from the pre-flash and the associated distance
information.
Pre-flash TTL A pre-flash is fired right before shooting, and the camera sets
the amount of flash light by measuring only the amount of
reflected light from the pre-flash. The distance information is
not used in the calculation.
Flash default
86

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sony DSLR-A100 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Sony DSLR-A100

Sony DSLR-A100 Bedienungsanleitung - Deutsch - 319 seiten

Sony DSLR-A100 Bedienungsanleitung - Deutsch - 39 seiten

Sony DSLR-A100 Bedienungsanleitung - Englisch - 19 seiten

Sony DSLR-A100 Bedienungsanleitung - Holländisch - 319 seiten

Sony DSLR-A100 Bedienungsanleitung - Holländisch - 39 seiten

Sony DSLR-A100 Bedienungsanleitung - Französisch, Italienisch - 319 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info