Bedienungsanleitung Sony FDR-AX1 (Seite 57 von 68) (Englisch)

548253

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

Important Notes on Operation

Appendices

LCD screen

• Do not exert excessive pressure on the LCD

screen, as it may cause damage.

• If your camcorder is used in a cold place, a

residual image may appear on the LCD screen.

This is not a malfunction.

• While using your camcorder, the back of the

LCD screen may heat up. This is not a

malfunction.

To clean the LCD screen

The surface of the LCD screen is coated. If you

scratch the surface, the coating may be come off.

Mind the following points when cleaning and

handling it.

• If hand grease or hand cream remains on the

screen, the coating comes off more easily. Wipe

it early.

• The coating may be scratched if you wipe the

screen with a tissue, etc.

• Remove the dust or sand with a blower, etc.

before wiping the dirt.

• Use a soft cloth (a cloth for glasses, etc.) gently

to clean the dirt.

On handling the casing

• If the casing is soiled, clean the camcorder body

with a soft cloth lightly moistened with water,

and then wipe the casing with a dry soft cloth.

• Avoid the following to avoid damage to the

finish.

—Using chemicals such as thinner, benzine,

alcohol, chemical cloths, repellent,

insecticide and sunscreen.

—Handling with above substances on your

hands.

—Leaving the casing in contact with rubber or

vinyl objects for a long period of time.

About care and storage of the lens

• Wipe the surface of the lens clean with a soft

cloth in the following instances:

—When there are fingerprints on the lens

surface.

—In hot or humid locations

—When the lens is exposed to salty air such as

at the seaside.

• Store in a well-ventilated location subject to

little dirt or dust.

• To prevent mold, periodically clean the lens as

described above.

On charging the pre-installed rechargeable

battery

Your camcorder has a pre-installed rechargeable

battery to retain the date, time, and other settings

even when the POWER switch is set to OFF. The

pre-installed rechargeable battery is always

charged while your camcorder is connected to the

wall outlet (wall socket) via the AC Adaptor or

while the battery pack is attached. The

rechargeable battery will be fully discharged in

about 3 months if you do not use your

camcorder at all without the AC Adaptor

connected or the battery pack attached. Use your

camcorder after charging the pre-installed

rechargeable battery.

However, even if the pre-installed rechargeable

battery is not charged, the camcorder operation

will not be affected as long as you are not

recording the date.

Removing dust from inside the

viewfinder

1 Remove the eye piece of the viewfinder.

Slide down the viewfinder release lever and

hold it at the position (1), then lift the eye

piece of the viewfinder as indicated with the

arrow in the illustration (2).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony FDR-AX1 Seite 57

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sony FDR-AX1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info