Bedienungsanleitung Sony hdr xr200e (Seite 49 von 64) (Englisch)

292219

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

Additional information

Troubleshooting

If you run into any problems using your

camcorder, use the following table to

troubleshoot the problem. If the problem

persists, disconnect the power source and

contact your Sony dealer.

Notes before sending your camcorder for repair

Your camcorder may be required to initialize or

change the current hard disk of your camcorder,

depending on the problem. In the event of this,

the data stored on the hard disk will be deleted.

Be sure to save the data on the internal hard

disk on other media (backup) before sending

your camcorder for repair (p. 27, 35). We will

not compensate you for any loss of hard disk

data.

During repair, we may check a minimum

amount of data stored on the hard disk in order

to investigate the problem. However, your Sony

dealer will neither copy nor retain your data.

See the Handycam Handbook (p. 48) for details

on the symptoms of your camcorder, and “PMB

Guide” (p. 31) on connecting your camcorder

to a computer.

The power does not turn on.

Attach a charged battery pack to the

camcorder (p. 10).

Connect the plug of the AC Adaptor to the

wall outlet (wall socket) (p. 11).

The camcorder does not operate even

when the power is set to on.

It takes a few seconds for your camcorder to

be ready to shoot after the power is turned on.

This is not a malfunction.

Disconnect the AC Adaptor from the wall

outlet (wall socket) or remove the battery

pack, then reconnect it after about 1 minute. If

your camcorder still does not work, press the

RESET button (p. 60) using a pointed object:

(If you press the RESET button, all settings,

including the clock setting, are reset.)

The temperature of your camcorder is

extremely high. Turn off the camcorder and

leave it for a while in a cool place.



The temperature of your camcorder is

extremely low. Leave the camcorder with the

power turned on. If you still cannot operate

your camcorder, turn off the camcorder and

take it to a warm place. Leave the camcorder

there for a while, then turn on the camcorder.

The camcorder gets warm.

Your camcorder may become warm during

operation. This is not a malfunction.

The power abruptly turns off.

Use the AC Adaptor (p. 11).

Turn on the power again.

Charge the battery pack (p. 10).

Pressing START/STOP or PHOTO does not

record images.

Press MODE to turn on the (Movie) or

(Photo) lamp (p. 12).

Your camcorder is recording the image you

have just shot on the recording media. You

cannot make new recording during this

period.

The recording media is full. Delete

unnecessary images (p. 39).

Total number of movie scenes or photos

exceeds the recordable capacity of your

camcorder. Delete unnecessary images (p. 39).

The recording stops.

The temperature of your camcorder is

extremely high/low. Turn off your camcorder

and leave it for a while in a cool/warm place.

”PMB” cannot be installed.

Check the computer environment or

installation procedure required to install

“PMB” (p. 24).

”PMB” does not work correctly.

Quit “PMB” and restart your computer.



Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony hdr xr200e Seite 49

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sony hdr xr200e

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info