Bedienungsanleitung Sony HT-6900DP (Seite 54 von 60) (Englisch)

36152

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

masterpage:Left

lename[E:\SEM_Janet\Revision_HT-

950DP\J9050000_25497361215950DPUS\2549736121\US09ADD_HT-5950DP-CA.fm]

Model name [HT-5950DP/HT-6900DP/HT-9900M/HT-9950M]

[2-549-736-12(1)]

Dolby Digital or DTS multi channel sound is

not reproduced.

• Check that the playing DVD, etc. is recorded in

Dolby Digital or DTS format.

• When connecting the DVD player, etc. to the

digital input jacks of this receiver, check the audio

setting (settings for the audio output) of the

connected component.

Recording cannot be done.

• Check that the components are connected

correctly.

• Select the source component with input buttons.

The FM reception is poor.

• Use a 75-ohm coaxial cable (not supplied) to

connect the receiver to an outdoor FM antenna as

shown below. If you connect the receiver to an

outdoor antenna, ground it against lightning. To

prevent a gas explosion, do not connect the ground

wire to a gas pipe.

Radio stations cannot be tuned in.

• Check that the antennas are connected securely.

Adjust the antennas and connect an external

antenna if necessary.

• The signal strength of the stations is too weak

(when tuning in with automatic tuning). Use direct

tuning.

• Make sure you set the tuning interval correctly

(when tuning in AM stations with direct tuning).

• No stations have been preset or the preset stations

have been cleared (when tuning by scanning

preset stations). Preset the stations (page 25).

• Press DISPLAY repeatedly so that the frequency

appears in the display.

There is no picture or an unclear picture

appears on the TV screen or monitor.

• Select the appropriate input on the receiver.

• Set your TV to the appropriate input mode.

• Move your audio components away from the TV.

Remote control

The remote does not function.

• The AUX, MULTI CH** and 12 buttons on the

remote are not available for receiver operation.

• Point the remote at the remote sensor on the

receiver.

• Remove any obstacles in the path between the

remote and the receiver.

• Replace all the batteries in the remote with new

ones, if they are weak.

• Check if the command modes of the receiver and

the remote is the same. If the command mode of

the receiver and the remote is different, you

cannot operate the receiver with the remote. To

switch the command mode of the receiver, press

?/1 to turn off the power. Then, press ?/1 while

pressing ENTER. Each time you press ?/1, the

command mode switches between

“C.MODE.AV2” and “C.MODE.AV1”. (The

initial setting is “C.MODE.AV2”.)

• Make sure you select the correct input on the

remote.

• To activate the buttons with orange printing, press

ALT first before pressing the buttons.

• Before you use the V/v/B/b button for receiver

operation, press MAIN MENU. To operate other

components, press TOP MENU/GUIDE or AV

MENU after pressing the input button.

** HT-5950DP only.

ANTENNA

Receiver

To ground

Ground wire

(not supplied)

Outdoor FM antenna

US01COV_HT-5950DP-CA.book Page 54 Monday, April 11, 2005 11:37 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony HT-6900DP Seite 54

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info