Bedienungsanleitung Sony HT-SL40 (Seite 17 von 44) (Englisch)

465693

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

HT-SL55 4-247-583-12(1) GB

Hooking Up and Setting Up the Speaker System

x Front speaker size (

XXXXX)

• If you connect large speakers that will

effectively reproduce bass frequencies, select

“LARGE”. Normally select “LARGE”.

• If the sound is distorted, or you feel a lack of

surround effects when using multi channel

surround sound, select “SMALL” to activate

the bass redirection circuitry and output the

front channel bass frequencies from the sub

woofer.

• When the front speakers are set to “SMALL”,

the center and surround speakers are also

automatically set to “SMALL” (unless

previously set to “NO”).

• When the sub woofer is set to “NO”, the front

speakers are automatically set to “LARGE” and

you cannot change the setting.

x Center speaker size (

XXXXX)

• If you connect a large speaker that will

effectively reproduce bass frequencies, select

“LARGE”. Normally select “LARGE”.

However, if the front speakers are set to

“SMALL”, you cannot set the center speaker to

“LARGE”.

• If the sound is distorted, or you feel a lack of

surround effects when using multi channel

surround sound, select “SMALL” to activate

the bass redirection circuitry and output the

center channel bass frequencies from the front

speakers (if set to “LARGE”) or sub woofer.*

• If you do not connect a center speaker, select

“NO”. The sound of the center channel will be

output from the front speakers.*

x Surround speaker size (

XXXXX)

• If you connect large speakers that will

effectively reproduce bass frequencies, select

“LARGE”. Normally select “LARGE”.

However, if the front speakers are set to

“SMALL”, you cannot set the surround

speakers to “LARGE”.

• If the sound is distorted, or you feel a lack of

surround effects when using multi channel

surround sound, select “SMALL” to activate

the bass redirection circuitry and output the

surround channel bass frequencies from the sub

woofer or other “LARGE” speakers.

• If you do not connect surround speakers, select

“NO”.*

Tip

*1–*3 correspond to the following Dolby Pro Logic

modes

*1 NORMAL

*2 PHANTOM

*3 3 STEREO

Tip

Internally, the LARGE and SMALL settings for each

speaker determine whether or not the internal sound

processor will cut the bass signal from that channel.

When the bass is cut from a channel, the bass

redirection circuitry sends the corresponding bass

frequencies to the sub woofer or other “LARGE”

speakers.

However, since bass sounds have a certain amount of

directionality, it best not to cut them, if possible.

Therefore, even when using small speakers, you can

set them to “LARGE” if you want to output the bass

frequencies from that speaker. On the other hand, if

you are using a large speaker, but prefer not to have

bass frequencies output from that speaker, set it to

“SMALL”.

If the overall sound level is lower than you prefer, set

all speakers to “LARGE”. If there is not enough bass,

you can use the BASS parameter in the TONE menu

to boost the bass levels. To adjust the bass, see page

25.

continued

GB04SPK_HT-SL55.p65 28/4/2003, 11:58 AM17

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony HT-SL40 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sony HT-SL40

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info