Bedienungsanleitung Sony HXR-NX5P (Seite 110 von 128) (Englisch)

460609

110

Zoom out

Zoom in

Vorherige Seite

1/128

Nächste Seite

110

F:\CX94000\4-157-878-111(GB)\4157878111HXRNX5E_GB\01GB11ADD.fm

HXR-NX5E/NX5P/NX5M

4-157-878-11(1)

– wash off any liquid that may have contacted

your skin.

– if any liquid gets in your eyes, wash with

plenty of water and consult a doctor.

x When not using your camcorder for a

long time

• Periodically turn on the camcorder and play

back images for about 3 minutes.

• Use up the battery pack completely before

storing it.

Moisture condensation

If your camcorder is brought directly from a

cold place to a warm place, moisture may

condense inside your camcorder and cause

a malfunction of your camcorder.

x If moisture condensation has occurred

Leave your camcorder for about 1 hour without

turning it on.

x Note on moisture condensation

Moisture may condense when you bring your

camcorder from a cold place into a warm place (or

vice versa) or when you use your camcorder in a

humid place as shown below.

• When you bring your camcorder from a ski

slope into a place warmed up by a heating

device.

• When you bring your camcorder from an air

conditioned car or room into a hot place outside.

• When you use your camcorder after a squall or a

shower.

• When you use your camcorder in a hot and

humid place.

x How to avoid moisture condensation

When you bring your camcorder from a cold place

into a warm place, put your camcorder in a plastic

bag and seal it tightly. Remove the bag when the

air temperature inside the plastic bag has reached

the ambient temperature (after about 1 hour).

LCD screen

• Do not exert excessive pressure on the LCD

screen, as it may cause damage.

• If your camcorder is used in a cold place, a

residual image may appear on the LCD screen.

This is not a malfunction.

• While using your camcorder, the back of the

LCD screen may heat up. This is not a

malfunction.

x To clean the LCD screen

If fingerprints or dust make the LCD screen dirty,

it is recommended you use a soft cloth to clean it.

When you use the LCD Cleaning Kit (sold

separately), do not apply the cleaning liquid

directly to the LCD screen. Use cleaning paper

moistened with the liquid.

On adjustment of the touch panel

(CALIBRATION)

The buttons on the touch panel may not

work correctly. If this happens, follow the

procedure below. It is recommended that

you connect your camcorder to the wall

outlet (wall socket) using the supplied AC

Adaptor/Charger during the operation.

1 Turn on the camcorder.

2 Press the MENU button t select

(OTHERS) t [CALIBRATION]

with the SEL/PUSH EXEC dial.

3 Touch “×” displayed on the screen with

the corner of memory card or the like 3

times.

• If you did not press the right spot, try the

calibration again.

• Touch [CANCEL] to cancel calibration.

b Notes

• Do not use a sharp-pointed object for

calibration. Doing so may damage the LCD

screen.

On handling the casing

• If the casing is soiled, clean the camcorder body

with a soft cloth lightly moistened with water,

and then wipe the casing with a dry soft cloth.

• Avoid the following to avoid damage to the

finish.

Maintenance and precautions (Continued)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony HXR-NX5P Seite 110

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info