Note
The unit conforms to IEEE802.3bt Type 4 Class 8. For details about verified compatible PoE++ power delivery devices, contact
your dealer or Sony service representative.
The unit is compliant with soft authentication (LLDP), but it may be necessary to configure network devices (IEEE802.3bt
compliant).
Do not connect an AC adaptor when using PoE++ power delivery with soft authentication (LLDP) enabled.
If an AC adaptor and PoE++ power delivery device are connected at the same time, power is supplied from the AC adaptor.
When supplying power via PoE++, use a Category 5e or higher network cable.
Wait about 10 seconds after turning the unit on again when powered via PoE++.
When using PoE++ power delivery, connect the ground terminal to ground.
When connecting via PoE++ power delivery, do not run wiring outdoors.
5-041-957-11(1) Copyright 2022 Sony Corporation
Check that the POWER lamp on the front of the unit changes from blinking green to solid green and that
startup has finished.
When the unit has started normally and connected to the network, the NETWORK lamp will light up green.
Note
When power is supplied by PoE++, initial authentication is performed during the interval until startup has finished.
When using a lens that does not support pan/tilt operation, lock the pan/tilt lock lever and skip the following steps. For
details about lenses that support pan/tilt, contact your dealer or Sony service representative.
3
Slide the pan/tilt lock lever to the UNLOCK position to unlock the pan/tilt of the camera head.
4
Reset the pan/tilt.
For details, see “Resetting the Pan/Tilt.”
5
