Bedienungsanleitung Sony KDL-32D26XX (Seite 6 von 35) (Englisch)

42866

Zoom out

Zoom in

Vorherige Seite

1/35

Nächste Seite

4 Press F/f to select the country/region in

which you will operate the TV, then press

If the country/region in which you want to use the

TV does not appear in the list, select “-” instead of

a country/region.

7: Auto-tuning the TV

1 Before you start auto-tuning the TV, insert

a pre-recorded tape into the VCR

connected to the TV (page 4) and start play

back.

The video channel will be located and stored on

the TV during auto-tuning.

If no VCR is connected to the TV, skip this step.

2 Press .

3 Press F/f to select “Antenna” or “Cable”,

then press .

If you select “Cable”, the screen for selecting the

scan type appears. See “To tune the TV for Cable

connection” (page 6).

The TV starts searching for all available digital

channels, followed by all available analogue

channels. This may take some time, so do not

press any buttons on the TV or remote while

proceeding.

If a message appears for you to confirm the aerial

connection

No digital or analogue channels were found.

Check all the aerial/cable connection and then

press to start auto-tuning again.

4 When the Programme Sorting menu

appears on the screen, follow the steps of

“Programme Sorting” (page 26).

If you do not change the order in which the

analogue channels are stored on the TV, go to

step 5.

5 Press MENU to exit.

The TV has now tuned in all the available

channels.

When a digital broadcast channel cannot be received, or

when selecting a region in which there are no digital

broadcasts in step 4 (page 6), the time must be set after

performing step 5.

To tune the TV for Cable connection

1 press .

2 Press F/f to select “Quick Scan” or “Full

Scan”, then press .

"Quick Scan" : channels are tuned according to

the cable operator information within the

broadcast signal.

Recommended setting for "Frequency", "Network

ID" and "Symbol Rate" is "Auto".

This option is recommended for fast tuning when

supported by your cable operator.

If the "Quick Scan" does not tune, please use the

"Full Scan" method below.

"Full Scan" : All available channels are tuned

and stored. This procedure may take some time.

This option is recommended when "Quick Scan"

is not supported by your cable provider.

For further information about supported cable

providers, refer to support web site:

http://support.sony-europe.com/TV/DVBC

3 Press G/g/f to select “Start”.

The TV starts searching for channels. Do not press

any buttons on the TV or remote.

Some cable providers do not support “Quick Scan”. If no

channels are detected using “Quick Scan”, perform “Full

Scan”.

Detaching the Table-

Top Stand from the TV

Do not remove the Table-Top Stand for any reason other than

to wall-mount the TV.

Auto Start Up

Language

Country

Select:

Confirm:

Back:

Start:

Cancel:

Do you want to start automatic tuning?

KDL-40S30xx

KDL-40D27xx

KDL-40D26xx

KDL-40T28xx

KDL-40T30xx

KDL-32S30xx

KDL-32D27xx

KDL-32D26xx

KDL-32T28xx

KDL-32T30xx

010COV.book Page 6 Friday, July 13, 2007 5:05 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony KDL-32D26XX Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sony KDL-32D26XX

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info