Bedienungsanleitung Sony LBTXG500 (Seite 26 von 32) (Englisch)

29916

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Troubleshooting

If you run into any problem using this unit, use

the following check list.

First, check that the power cord is connected

firmly and the speakers are connected correctly

and firmly.

Should any problem persist, consult your

nearest Sony dealer.

General

The display starts flashing as soon as you plug

in the power cord even though you haven’t

turned on the power.

• Refer to demonstration (see page 7, step 4).

The clock setting is canceled.

• The power cord is disconnected or a power

failure occurs. Redo “Setting the time” (on page

8). If you have set the timer, redo “Waking up to

music” (on page 22) and “Timer-recording radio

programs” (on page 17).

The radio presetting/timer setting is canceled.

• The power cord is disconnected or a power

failure occurs for longer than half a day. Redo

“Presetting radio stations” (on page 12).

There is no sound.

• The jumpers for the DJ MIX jacks are not

connected (for European, North American, and

Mexican models only).

• Turn VOLUME clockwise.

• The headphones are connected.

• Insert only the stripped portion of the speaker

cord into the SPEAKER jack. Inserting the vinyl

portion of the speaker cord will obstruct the

speaker connections.

• The protective device on the amplifier has been

activated because of a short circuit.

(“PROTECT” and “PUSH POWER” flash

alternately.) Turn off the unit, eliminate the

short-circuit problem and turn on the power

again.

• There is no audio output during timer recording.

There is no microphone sound.

• Turn VOLUME or MIC LEVEL to adjust the

microphone volume.

• Make sure the microphone is connected to the

MIX MIC jack correctly.

There is no guitar sound.

• Turn VOLUME or GUITAR LEVEL to adjust

the guitar volume.

• Make sure the guitar is connected to the

GUITAR jack correctly.

• Select “MIX GUITAR/KARAOKE” by pressing

MIX GUITAR/KARAOKE.

There is severe hum or noise.

• A TV or VCR is placed too close to the stereo

system. Move the stereo system away from the

TV or VCR.

“0:00” (or “12:00 AM”) flashes in the display.

• A power interruption occurred. Set the clock and

timer settings again.

The timer does not function.

• Set the clock correctly.

DAILY and REC do not appear when you press

the c/CLOCK SET button.

• Set the timer correctly.

• Set the clock.

The remote does not function.

• There is an obstacle between the remote and the

system.

• The remote is not pointing in the direction of the

system’s sensor.

• The batteries have run down. Replace the

batteries.

There is acoustic feedback.

• Decrease the volume level.

• Move the microphone away form the speakers or

change the direction of the microphone.

The color irregularity on a TV screen persists.

• Turn off the TV set once, then turn it on after 15

to 30 minutes. If the color irregularity still

persists, place the speakers farther away from the

TV set.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony LBTXG500 Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info