Bedienungsanleitung Sony mz-rh10 (Seite 73 von 119) (Englisch)

157187

Zoom out

Zoom in

Vorherige Seite

1/119

Nächste Seite

Recording cannot be

done correctly.

• Recording may not be done if the remaining recordable time on the

disc is 48 seconds or less (“DISC FULL” appears).

, Replace the disc.

The lid does not open

after recording.

• The lid does not open until “SYSTEM FILE WRITING” disappears

in the display.

“TRACK FULL”

appears even before the

disc has reached the

maximum recording

time and the recording

cannot be done.

• This is due to the MiniDisc system limitation. When 2,047 tracks (on

a disc used in Hi-MD mode) have been recorded on the disc,

“TRACK FULL” appears regardless of the total recorded time. More

than 2,047 tracks cannot be recorded on the disc.

, To continue recording, erase unnecessary tracks.

The remaining

recording time does not

increase even after

erasing numerous short

tracks.

• This is due to the MiniDisc system limitation (in MD mode only).

Tracks of under 12 seconds (in SP mode), 24 seconds (in LP2 mode

or monaural), or 48 seconds (in LP4 mode) in length are not counted

and so erasing them may not lead to an increase in the recording

time.

The total recorded time

and the remaining time

on the disc may not total

the maximum recording

time (60, 74, or 80

minutes).

• This is due to the MiniDisc system limitation (in MD mode only).

Normally, recording is done in minimum units of approximately 2

seconds (in SP mode), 4 seconds (in LP2 mode or monaural), or 8

seconds (in LP4 mode). When recording is stopped, the last unit of

recording always uses this unit of 2 seconds, 4 seconds, or 8 seconds

even if the actual recording is shorter. Likewise, when recording is

restarted after the stop, the recorder will automatically insert a blank

space amounting to 2 seconds, 4 seconds, or 8 seconds before the

next recording. (This is to prevent accidental erasing of a previous

track whenever a new recording is started). Therefore, the actual

recording time will decrease whenever a recording is stopped by a

maximum of 6 seconds, 12 seconds, or 24 seconds.

“TRACK FULL”

appears even before the

disc has reached the

maximum track number

or recording time.

• This is due to the MiniDisc system limitation. Repeated recording

and erasing may cause fragmentation and scattering of data.

Although those scattered data can be read, each fragment is counted

as a track. In this case, the number of tracks may reach 2,047 (on a

disc used in Hi-MD mode) and further recording is not possible.

, To continue recording, erase unnecessary tracks.

Symptom Cause/Remedy

While playing

Symptom Cause/Remedy

A disc is not played

normally.

• Repeat play is selected.

, Set the Repeat play to “Off” to change back to the normal play

(page 42).

• Playback mode is changed.

, Enter the Main play mode or Sub play mode to change back to

the normal play (page 40).

A disc is not played from

the first track.

• Disc playing stopped before it came to the last track.

, Press the jog dial (N/ENT) on the recorder or press NX on

the remote control for 2 seconds or more to start playing.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony mz-rh10 Seite 73

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sony mz-rh10

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info