Bedienungsanleitung Sony nv-u71t (Seite 17 von 148) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch)

162262

Zoom out

Zoom in

Vorherige Seite

1/148

Nächste Seite

Resetting the unit

If the navigation software freezes, try resetting

the unit.

Switch off the main power by sliding the

POWER switch to the OFF position, then switch

on again after approximately 10 seconds.

Note

After you switch off the main power, it may take time to

receive GPS signals when switching on again.

The built-in battery cannot be charged.

t Check that the POWER switch on the bottom right

of the unit is in the ON position.

t If the AC power adapter is being used, disconnect it

from the outlet, then reconnect.

t The built-in lithium-ion battery can be charged at

temperatures between 5 – 45 ºC (41 – 113 ºF). The

battery may not be charged if the temperature

inside the unit increases because of direct sunlight

exposure, etc. This is not a malfunction.

GPS signal cannot be received.

Firstly, read the GPS overview (page 4), then check the

GPS status by selecting “More…” in the top menu c

“GPS Status.”

• The system cannot receive GPS signals due to an

obstruction.

t Move your car to a place where signals can be

received clearly.

• GPS signal reception is low.

t The optional External GPS Antenna VCA-41

may be required for a heated or heat reflective

windscreen.

• There is an obstacle in front of the GPS aerial.

t Install the unit where the signal is not interrupted

by the body of the car, etc.

• Signal may not be received if a window film is

attached.

t Use the optional External GPS Antenna VCA-41.

The car position on the map does not match

the current road.

The error margin of the signal from the GPS satellites

is too large. A maximum error margin of a few

hundred metres can exist.

Voice guidance cannot be heard.

The volume is set too low.

t Raise the volume (page 10).

When the unit is powered by the built-in battery,

volume may slightly decrease.

The LCD is not displayed normally.

• In high temperatures, the LCD may darken and not

display clearly. In low temperatures, afterimage may

occur on the LCD. These are not malfunctions, and

the LCD will return to normal when the temperature

returns to within the specified operating range.

• The LCD is dark.

t The auto dimmer function may be activated

because its sensor 7 (page 5) is covered by a

hand, etc.

The cradle comes off the attachment surface.

Attachment strength weakens if the surface of the

suction cup or attachment surface becomes dirty.

t Wash and clean the suction cup and the attachment

surface (page 14).

The demonstration mode starts automatically

even if no operation is performed.

t Turn off the auto demonstration mode by selecting

“More…” in the top menu c “Settings” c “General

Settings” c “Demo Mode.” Then, confirm that

“Demo Mode” is set to off.

POWER

ONOFF

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony nv-u71t Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info