Bedienungsanleitung Sony NVXHC1 (Seite 21 von 130) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

25945

Zoom out

Zoom in

Vorherige Seite

1/130

Nächste Seite

01GB02CD-EUR.fm masterpage:Right

NVX-HC1

2-583-235-11 (1)

Troubleshooting

The following checklist will help you remedy

problems you may encounter with your unit.

Before going through the checklist below, check

the connection and operating procedures.

Error message

When “Please Set Original Disc in NAVI Unit”

keeps appearing after inserting the supplied

DVD-ROM, consult your nearest Sony dealer.

General

The operation buttons do not function.

• TA (traffic announcement) is interrupting.

t Wait until the TA interruption finishes.

t Cancel the TA function by pressing

(MODE), or (TA) on the card remote

commander.

• Press the reset button (page 9).

GPS signal cannot be received.

• The system cannot receive GPS signals due

to an obstruction.

t Move your car somewhere clear.

• GPS signal reception is low.

t Check the GPS signal values.

• The GPS aerial is incorrectly installed.

t Install the GPS aerial where the signal is

not interrupted by the body of the car, etc.

and install the aerial horizontally. For

details, see the Installation/Connections

manual.

• The GPS aerial is not properly connected to

the unit.

t Insert the connector of the aerial until it

clicks into the GPS ANT. IN port of the

unit. For details, see the Installation/

Connections manual.

The car position on the map does not match

the current road.

The error margin of the signal from the GPS

satellites is too large. A maximum error

margin of a few hundred metres can exist.

t Search for the route again and update your

current car position. For details, see

“Searching for the route again” on page 17.

• Lead-free solder is used for soldering certain

parts. (more than 80 %)

• Halogenated flame retardants are not used in the

certain printed wiring boards.

• Halogenated flame retardants are not used in

cabinets.

• Packaging cushions do not use polystyrene foam.

The guidance patterns cannot be changed

by pressing (MAP).

• The patterns cannot be changed when you

are on the motorway.

• The current car position does not appear on

the route right after guidance started.

t Wait unit the current car position appears

on the road map.

The voice guidance cannot be heard.

• The volume is too low.

t Press (+) (VOL) on the card remote

commander or rotate the L dial clockwise

to adjust the volume.

• The ATT function of the main unit is

activated.

t Cancel the ATT function of the main unit.

“s” appears on the display.

The characters on the route guidance display

complies with ISO 8859-1 character set,

incompatible characters are shown as “s.”

Arrow guidance “M” appears for a while.

• The system still calculates the direction on

the route right after guidance started.

• There is no way to make a right or left turn

for a while.

• The distance to the next turning point is over

5 km (3 miles) for general roads and 10 km

(6 miles) for motorways.

Estimated travel distance, travel time or

arrival time is not displayed.

The current car position does not appear on the

route right after guidance started, and the

system still calculates the route information.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony NVXHC1 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info