Bedienungsanleitung Sony PSP-E1004 (Seite 9 von 40) (Englisch)

513254

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

Warning and caution

Precautions

Moisture condensation

If the PSP® system or Universal Media Disc is brought directly from

a cold location to a warm one, moisture may condense on the lens

inside the system or on the Universal Media Disc. Should this occur,

the system may not operate properly. In this case, remove the

Universal Media Disc and turn off and unplug the system. Do not

put the Universal Media Disc back in until the moisture evaporates

(this may take several hours). If the system still does not operate

properly, contact the appropriate PSP

® customer service helpline

which can be found within every PSP

® format software manual.

Universal Media Disc handling



Do not touch the opening on the rear of the disc (recorded surface

of the disc) with your fingers.



Do not allow dust, sand, foreign objects or other types of dirt to

get on the disc.



If the Universal Media Disc becomes dirty, gently wipe the

exterior and recorded surfaces of the Universal Media Disc using

a soft cloth. Do not use solvents or other chemicals.



Do not use a Universal Media Disc that is cracked or warped or

has been repaired. The Universal Media Disc may break inside

the PSP

® system, leading to injury or malfunction.

Handling and care of exterior surfaces

Follow the guidelines listed below to help avoid deterioration or

discolouration of the PSP

® system.



Do not use solvents or other chemicals to clean the exterior

surface.



Do not allow the system to remain in direct contact with rubber or

vinyl products for an extended period of time.



Do not use a chemically-treated cleaning cloth to wipe off the

system.

Before using the analog stick



Do not attempt to remove the analog stick from the system front,

as doing so will damage the system and may result in injury.



For best results, go to

(Settings) (System Settings),

and then with the [System Information] screen displayed, rotate

the analog stick in a circular motion to adjust the analog stick’s

range of movement.

Cleaning

For safety reasons, unplug the AC adaptor from the electrical outlet

and disconnect any other cables before cleaning the system.

Cleaning the exterior surface and LCD screen

Wipe gently with a soft cloth.

Cleaning the connectors

If the connectors on the PSP® system or on the USB cable become

dirty, signals may not be sent or received properly. Also, if the

connector on the headphones becomes dirty, you may experience

noise or interruptions in sound. Wipe the connectors with a dry, soft

cloth to keep in clean condition.

Cases and coverings

When placing the PSP® system in a commercially available case,

turn off the power or put the system in sleep mode. Do not use the

system while it is in the case. Leaving the system on, or using it

while in a case or covering may cause overheating or may damage

the system.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony PSP-E1004 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info