Bedienungsanleitung Sony RDR-GX210 (Seite 82 von 96) (Englisch)

21227

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite

, Other timer setting overlapped the timer setting

(page 42).

, There is not enough disc space for the recording.

, The PDC/VPS function is working (page 39).

Contents previously recorded were erased.

, Data that has been recorded on a DVD with a PC

will be erased from the disc when the disc is

inserted.

The PDC/VPS function does not operate.

, Check that the clock and date are set correctly.

, Check that the PDC/VPS time you set is the

correct one (there might be a mistake in the TV

programme guide). If the broadcast you wanted

to record did not send the good PDC/VPS

information, the recorder will not start recording.

, If the reception is poor, the PDC/VPS signal

might be altered and the recorder might not start

recording.

, [PDC/VPS] is set to [Off] (page 39).

Display

The clock has stopped.

, Set the clock again (page 72).

, The clock stopped due to a power failure. Reset

the clock (page 72).

The TIMER REC indicator is flashing.

, The disc does not have enough space.

, Insert a recordable disc inside the recorder.

The recording mode indication is incorrect.

, When the recording or dubbing is less than three

minutes, the recording mode indication may be

displayed incorrectly. The actual recording itself

is correctly made in the selected recording mode.

Remote control

The remote does not function.

, Batteries are weak.

, The remote is too far from the recorder.

, The remote’s manufacturer code returned to the

default setting when you replaced the batteries.

Reset the code (page 19).

, Turn on the recorder.

, The remote is not pointed at the remote sensor on

the recorder.

, Different command modes are set for the

recorder and remote. Set the same command

mode (page 20).

, Set the TV/DVD switch to DVD (page 19).

Other Sony equipment responds to the remote.

, The same command mode is set for both the

equipment and recorder. Set a different

command mode for the recorder (page 20).

Others

The recorder does not operate properly.

, Restart the recorder. Press down "/1 on the

recorder for more than ten seconds to turn off the

recorder. If a disc is still in the recorder, press Z

(open/close) and remove the disc.

, When static electricity, etc., causes the recorder

to operate abnormally, turn off the recorder and

wait until the clock appears in the front panel

display. Then, unplug the recorder and after

leaving it off for a while, plug it in again.

The disc tray does not open after you press Z

(open/close).

, It may take a few seconds for the disc tray to

open after you have recorded or edited a disc.

This is because the recorder is adding disc data to

the disc.

Mechanical sound is heard when the recorder

is off.

, While the recorder is adjusting the clock for the

Auto Clock Set function or scanning the

channels for the PDC/VPS function, operational

noises (such as the internal fan) may be heard,

even when the power is off. This is not a

malfunction.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony RDR-GX210 Seite 82

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sony RDR-GX210

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info