Bedienungsanleitung Sony RDR-HX780 (Seite 120 von 140) (Englisch)

107538

120

Zoom out

Zoom in

Vorherige Seite

1/140

Nächste Seite

120

, If the audio signal does not come through

the DIGITAL OUT (COAXIAL)/HDMI

OUT jacks, check the “Audio Out” setup

(page 107).

, The recorder supports only MP3 audio,

Dolby Digital and MPEG audio for DivX

video files. Press AUDIO and select MP3

audio or MPEG audio.

No sound is output from the HDMI OUT

jack.

, Try the following: 1Turn the recorder off

and on again.

2Turn the connected

equipment off and on again.

3Disconnect

and then connect the HDMI cord again.

, The HDMI OUT jack is connected to a

DVI device (DVI jacks do not accept audio

signals).

, The equipment connected to the HDMI

OUT jack does not conform to the audio

signal format. In this case, set “Audio

Output” to “PCM” in the “HDMI Output”

setup (page 114).

Sound distortion occurs.

, Set “Tuner Level” in the “Audio In” setup

to “Compression” (page 106).

Sound is noisy.

, When playing a CD with DTS sound

tracks, noise will come from the LINE 2

OUT R-AUDIO-L jacks, LINE 3 – TV

jack, or LINE 1/DECODER jack

(page 52).

The sound volume is low.

, The sound volume is low on some DVDs.

The sound volume may improve if you set

“Audio DRC” in the “Audio Out” setup to

“On” (page 108).

, Set “Tuner Level” in the “Audio In” setup

to “Normal” (page 106).

An alternate audio track cannot be

recorded or played.

, When recording from connected

equipment, set “External Audio” to

“Bilingual” in the “Audio In” setup

(page 106).

, Multilingual tracks (main and sub) cannot

be recorded on the HDD (when Video

Mode On), DVD+RWs, DVD-RWs

(Video mode), DVD+Rs, or DVD-Rs

(Video mode). To record the language, set

“Bilingual Recording” in the “Audio In”

setup to “A/L” or “B/R” before recording

(page 107). To record both the main and

sub sounds on a disc, record on DVD-

RWs/DVD-Rs (VR mode). To record on

the HDD, set “HDD Recording Format” to

“Video Mode Off” in the “Recording”

setup (page 111).

, If you have connected an audio component

to the DIGITAL OUT (COAXIAL) jack

and want to change the audio track for the

HDD (when “HDD Recording Format” is

set to “Video Mode Off” in the

“Recording” setup (page 111))/DVD-

RWs/DVD-Rs (VR mode) during

playback, set “Dolby Digital Output” in

the “Audio Out” setup to “Dolby Digital

-> PCM” (page 107).

The programme position cannot be

changed from the programme position

you are recording.

, Set the TV’s input source to “TV.”

Recording does not start immediately

after you press z REC.

, Operate the recorder only after “LOAD,”

“FORMAT,” or “INFO WRITE”

disappears from the front panel display.

Nothing was recorded even though you

set the timer setting correctly.

, There was a power failure during

recording.

, The recorder’s internal clock stopped due

to a power failure that lasted for more than

1 hour. Reset the clock (page 100).

, The channel was disabled after the timer

recording was set. See “Manual CH

Setting” on page 102.

, Disconnect the mains lead from the mains,

and connect it again.

, The programme contains copy protection

signals that restrict copying.

Recording/Timer recording/

Editing

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony RDR-HX780 Seite 120

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sony RDR-HX780

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info