Bedienungsanleitung Sony rm vl 600 t (Seite 14 von 36) (Englisch)

122744

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

If the SET indicator flashes five times

It means that “learning” is incomplete. Repeat steps 4

and 5.

6 Repeat Steps 4 and 5 to “teach” functions

to other buttons.

To “teach” another component’s remote

control signal

After positioning the two remote commanders as in

Step 1 on page 12, press the corresponding Component

Select button, and then follow Steps 4 and 5 to perform

Learning.

7 Press SET to finish setting.

Notes

• If you do not perform Learning steps within 20 seconds

at any point during the process, Learning mode ends.

• If you do not perform Step 5 within 10 seconds after Step

4, the learning procedure returns to Step 3. Repeat Step 4

while the Component Select button lights.

To cancel setup, press SET.

If the Commander does not seem to be

working

If the “learned” button does not operate properly, “teach”

once again. (For example, if the volume becomes very loud

after pressing 2 + only once, noise may have interfered

during the Learning procedure.)

If you set a component code after “learning” a

signal

If you have programmed any signal on a button by the

Learning function, that signal will work even after you set

a component code.

Note on the REC z signal

You can only “teach” to one button at a time. Therefore you

cannot teach a sequential button operation (for example

REC z + B) to a single button on the Commander. In this

case, “teach” the combined function of the buttons on your

component to the Commander.

When you “teach” signals to 2 +/– or %

•If you used the Learning

function to programme

the 2 +/–

or % buttons to send any signal to

components other than the TV or AMP, that signal

will be transmitted only by pressing 2 +/– or %

when you select that component.

•If you used the Learning

function to programme

the 2 +/–

or % buttons to send any signal to the

TV or AMP, that signal will be transmitted only

after you select TV or AMP. When you select other

components, the “learned” signal will be

transmitted.

To “teach” the signals for an

air-conditioner

See “Notes on programming the signals for an air-

conditioner” on page 18.

For accurate Learning

•Do not move the remote units during the

Learning procedure.

•Be sure to keep holding down the “learning”

button until your Commander reacts as described.

•Use fresh batteries in both remote units.

•Avoid Learning in places subject to direct sunlight

or a strong fluorescent light. (Noise may interfere

during the Learning procedure.)

•The remote control detector area may differ

depending on each remote unit. If Learning does

not work, try changing the positions of the two

remote control units.

•When you teach signals of an interactive signal

exchange system remote control unit (supplied

with some of Sony’s amplifiers) to the

Commander, the response signal of the main unit

may interfere with the learning of the

Commander. In such a case, move to a place

where the signals will not reach the main unit (e.g.

other rooms, etc.).

IMPORTANT

Be sure to place the Commander out of the reach

of small children or pets, and lock the controls

using the Hold function (page 25).

Components such as air - conditioners, heaters,

electric appliances, and electric shutters or

curtains receiving an infrared signal can be

dangerous if misused.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony rm vl 600 t Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sony rm vl 600 t

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info