Bedienungsanleitung Sony SDM-M61 (Seite 21 von 104) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

47839

Zoom out

Zoom in

Vorherige Seite

1/104

Nächste Seite

G:\_Upload\4084256121\4084256121SDMM61AEP\02GB-SDMM61AEP\01GB02BAS-UC.fm

masterpage:Right

SDM-M61

4-084-256-12(1)

Self-diagnosis function

This monitor is equipped with a self-diagnosis function. If there is

a problem with your monitor or computer(s), the screen will go

blank and the 1 (power) indicator will either light up green or

flash orange. If the 1 (power) indicator is lit in orange, the

computer is in power saving mode. Try pressing any key on the

keyboard or moving the mouse.

If the 1 (power) indicator is green

Turn off the 1 (POWER) switch and disconnect the

video signal cables from the monitor.

Turn the monitor on by pressing the 1 (POWER)

switch.

If all four color bars appear (white, red, green, blue), the monitor

is working properly. Reconnect the video input cables and check

the condition of your computer(s).

If the color bars do not appear, there is a potential monitor failure.

Inform your authorized Sony dealer of the monitor’s condition.

If the 1 (power) indicator is flashing orange

Press the 1 (power) switch twice to turn the monitor off

and then on.

If the 1 (power) indicator lights up green, the monitor is working

properly.

If the 1 (power) indicator is still flashing, there is a potential

monitor failure. Count the number of seconds between orange

flashes of the 1 (power) indicator and inform your authorized

Sony dealer of the monitor’s condition. Be sure to note the model

name and serial number of your monitor. Also note the make and

model of your computer and graphics board.

Specifications

LCD panel Panel type: a-Si TFT Active Matrix

Picture size: 16.0 inch

Input signal format RGB operating frequency*

Horizontal: 28 – 92 kHz

Vertical: 48 – 85 Hz

Resolution Horizontal: Max.1280 dots

Vertical: Max.1024 lines

Video input connector Analog RGB: HD15

Digital/analog RGB: DVI-I 29 pins

Input signal levels Analog RGB video signal:

0.7 Vp-p, 75 Ω, positive

SYNC signal:

TTL level, 2.2 kΩ,

positive or negative

(Separate horizontal and vertical,

or composite sync)

0.3 Vp-p, 75 Ω, negative

(Sync on green)

Digital RGB (DVI) video signal:

TMDS (Single link)

Audio output 1 W × 2

Headphones jack Stereo minijack

Accepts impedance of 16 – 48 Ω

AUDIO IN jack Stereo minijack × 2

Accepts impedance of 47 kΩ

Accepts level 0.5 Vrms

Power requirements 100 – 240 V, 50 – 60 Hz,

0.7 – 0.35 A

Power consumption Max. 35 W

Operating temperature 5 – 35

°C

Dimensions (w/h/d) Display (upright):

Approx. 400 × 357 × 180 mm

(15

× 14

× 7

/8 inches)

(with stand)

Approx. 400 × 318 × 57 mm

(15

× 12

× 2

/4 inches)

(without stand)

Mass Approx. 5.4 kg (11 lb 14 oz) (with

stand)

Plug & Play DDC2B

Accessories See page 7.

* Recommended horizontal and vertical timing condition

• Horizontal sync width duty should be more than 4.8% of total

horizontal time or 0.8 µs, whichever is larger.

• Horizontal blanking width should be more than 2.5 µsec.

• Vertical blanking width should be more than 450 µsec.

Design and specifications are subject to change without notice.

1 (power)

indicator

01GB02BAS-UC.book Page 21 Monday, July 2, 2001 2:26 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony SDM-M61 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info