Bedienungsanleitung Sony SNC-VM772R (Seite 37 von 68) (Englisch)

699841

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

Administrating the Camera

Security Menu — Setting the Security

Full: The user can operate all functions except deleting

the recorded movie in the memory card.

Light: In addition to the View mode, the user can select

the image size of the viewer, select codec and capture

a still image.

View: The user can only monitor the camera image.

For the functions available for each viewer mode, see

“Administrator and User” on page 10.

Viewer authentication

Set whether the user is authenticated or not when the

viewer is displayed.

When the checkbox is selected, the viewer is displayed

in accordance with the viewer mode of the authenticated

user. When the checkbox is not selected, select the

viewer mode of the viewer which is displayed without

authentication from Full, Light or View.

Note

Setting viewer authentication can prevent unintended

third parties from viewing the video. Without setting the

viewer authentication, people can view the video

without inputting a user ID or password. To prevent

unintended third parties from viewing the video, we

strongly recommend for you to set viewer authentication

and change the password on a regular basis.

Authentication mode

Set the authentication method for user authentication.

Basic authentication: Use the basic access

authentication.

Digest authentication: Use the digest access

authentication.

Note

If you change the settings in Authentication mode,

close the web browser and access again.

Access limit Tab

This allows you to control which computers can have

access to the camera.

Likewise, when using IPv6, security settings can be

configured for each network.

Enable

Select the checkbox to enable the access limit.

Default policy

Select the basic policy of the limit from Allow and Deny

for the computers specified in the Network address/

Subnet 1 to Network address/Subnet 10 menus below.

Network address/Subnet 1 to Subnet 10

Type the network addresses and subnet mask values that

you want to allow or deny access to the camera.

You can specify up to 10 network addresses and subnet

mask values. For a subnet mask, type 8 to 32.

(In the case of IPv6, enter a value between 8 and 128.)

Select Allow or Deny from the drop-down list on the

right for each network address/subnet mask.

Tip

The subnet mask value represents the bit number from

the left of the network address.

For example, the subnet mask value for “255.255.255.0”

is 24.

If you set 192.168.0.0/24 and Allow, you can allow

access from computers having an IP address between

“192.168.0.0” and “192.168.0.255”.

Note

You can access the camera even from a computer having

an IP address whose access right is set to Deny, if you

enter the user name and password set for the

Administrator boxes in the User menu.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony SNC-VM772R Seite 37

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sony SNC-VM772R

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info