Bedienungsanleitung Sony STR-DH590 (Seite 45 von 56) (Englisch)

699406

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

D:\NORM'S JOB\SONY HA\SO17_STR-DH590_PMRF1\STR-DH590 (PMRF

01)\4726906121_GB\070TRU.fm

masterpage: Right

STR-DH590

4-726-906-12(1)

Troubleshooting/Specifications

• The pairing registration information has

been erased. Perform the pairing

operation again.

• While connected to a BLUETOOTH device,

this receiver cannot be detected.

• Erase the pairing registration information

of the BLUETOOTH device on the

BLUETOOTH device and perform the

pairing operation again.

The sound skips or fluctuates, or the

connection is lost.

• The receiver and the BLUETOOTH device

are too far apart.

• If there are obstructions between the

receiver and your BLUETOOTH device,

remove these or move the receiver

and/or device avoid them.

• If there is a device that generates

electromagnetic radiation, such as a

wireless LAN, other BLUETOOTH device,

or a microwave oven nearby, move it

away.

The sound of your BLUETOOTH

device cannot be heard on the

receiver.

• Turn up the volume on your BLUETOOTH

device first, and then adjust the volume

using  + on the remote control (or

MASTER VOLUME on the receiver).

Severe humming or noise.

• If there are obstructions between the

receiver and your BLUETOOTH device,

remove them or move the receiver

and/or device avoid them.

• If there is a device that generates

electromagnetic radiation, such as a

wireless LAN, other BLUETOOTH device,

or a microwave oven nearby, move it

away.

• Turn down the volume of the connected

BLUETOOTH device.

The remote control does not

function.

• Point the remote control at the remote

control sensor on the receiver.

• Remove any obstructions between the

remote control and the receiver.

• Replace both of the batteries in the

remote control with new ones if they are

weak.

“PROTECT” appears on the display

panel.

The receiver will automatically turn off after

a few seconds. Check the followings:

Unplug the AC power cord (mains lead) and

let the receiver cool down for 30 minutes

while performing the following

troubleshooting:

– Disconnect all of the speakers and

subwoofer.

– Check that the speaker wires are tightly

twisted on both ends.

– Check that the receiver is not covered

and ventilation holes are not blocked.

– Check that the nominal impedance of the

connected speakers fall within the

impedance range indicated on the rear

panel of the receiver.

– Connect the front speaker first, plug in

the AC power cord (mains lead) and turn

on the receiver. Increase the volume level

and operate the receiver for at least

30 minutes until it completely warms up.

Then, connect each additional speaker

one by one and test each additional

speaker until you detect which speaker is

causing the protection error.

After checking the above items and fixing

any problems, plug in the AC power cord

(mains lead) and turn on the receiver. If the

problem persists, consult your nearest

Sony dealer.

Remote control

Error messages

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony STR-DH590 Seite 45

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sony STR-DH590

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info